Installation - Vented To The Outside - GE Monogram ZV30H Installation Instructions Manual
30" woll-mounted hood
Hide thumbs
Also See for Monogram ZV30H:
- Owner's manual (32 pages) ,
- Owner's manual (32 pages) ,
- Installation instructions manual (56 pages)
Table of Contents
Available languages
Available languages
Installation
Instructions
INSTALLATION - VENTED TO THE OUTSIDE
I-_IMOUNTING HOOD TO BOTTOM OF
CABINET (Continued)
• To secure the riser to the cabinet, place the riser
(with louvers facing the wall/under
the cabinet. Align
the riser and cabinet mounting holes. Drive 4 sup-
plied wood screws to install the riser to the cabinet.
NOTE: If desired, you may choose to install the
riser with the louvers facing forward.
Riser
Wood screws
• Drive 4 hood mounting
screws into the threaded
nuts on the bottom of the riser leaving 1/4" pro-
truding from the riser. The 1/4" gap will provide
the clearance to engage the key hole slots in the
top of the hood.
___.o
nting_/__
L_
• Install the dumper assembly on top of the hood
with 4 Phillips screws supplied.
#2 Phillips
screws
Dumper
assembly
#2
screws
I-_IMOUNTING HOOD TO BOTTOM OF
CABINET (Continued)
• Lift the hood to the installation
position. Locate the
house wiring and route it through the knockout on
top of the hood. Lift the hood and engage the key
hole slots over the mounting screws and slide it
buck against the wall. Tighten the mounting screws.
Add 2 additional
screws at the front center of the
riser.
• Install 4 wall screws and washers into the anchors
or studs to complete
the hood mounting.
Mounting screw
Key hole slot
in hood
12
Chapters
Table of Contents
