GE JGP628 Installation Instructions Manual page 14
36" sealed gas cooktop
Hide thumbs
Also See for JGP628:
- Technical service manual (38 pages) ,
- Installation instructions manual (33 pages) ,
- Owner's manual (24 pages)
Table of Contents
Available languages
Available languages
Installation
Instructions
MAKING THE LP CONVERSION (CONT.)
CHANGE COOKTOP BURNER
ORIFICES
Remove the top grates,
burner cops, and burner
heads.
Remove the spark
igniters from the burner
bose (if required to
access the orifices).
Using o No. 15 "Torx"
head driver bit, remove
the screws holding the
burner bose in position.
emove This
Assembly
Orifice Spud Located
Through This Opening
Using u 7mm nut driver,
remove the top burner
orifices. These may be
accessed through
the
hole in the cooktop.
Burner
cap
18,000 BTU Burner
Ion some models)
Burner
cop
_Burner
Burner
@head
base
Spark igniter
CHANGE COOKTOP BURNER
ORIFICES (CONT.)
NOTE: On most burners,
the orifices hove o spring-
Retainer
loaded retaining
ring Ground
Ring
the hex head to hold the
orifice in the nut driver during
installation
and removal. A
slight amount of force is required to push the nut
driver down over the ring.
14
Table of Contents
