GE 36" CUSTOM HOOD INSERT ZVC36LSS Dimensions And Installation Information
36" custom hood insert
Hide thumbs
Also See for 36" CUSTOM HOOD INSERT ZVC36LSS:
- Installation instructions manual (24 pages) ,
- Owner's manual (16 pages) ,
- Installation instructions manual (21 pages)
Quick Links
ZVC36LSS
GE Monogram
Custom Insert Liner
The custom canopy must be sized to fit the insert sleeve.
Construct the canopy with an opening that is:
26"W x 13-3/16"D
The opening must be constructed of 3/4" thick material to
allow the sleeve locking clips to engage.
The Supplied Liner
A stainless steel liner is shipped with each hood insert. This
non-combustible liner protects the underside of the canopy.
Custom Liner
If you are not using the supplied liner, you may construct a
custom non-combustible liner. Use the supplied liner as a
template. The opening must be 26"W x 13-3/16"D. 3/4" thick
material must surround the opening to allow the sleeve
locking clips to engage. The insert sleeve inside the cabinet
should be positioned 1/2" from the rear wall so that the
center of the 8" duct is 5-1/2" from the rear wall.
For answers to your Monogram,
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
800.626.2000.
36" Custom Hood Insert
®
GE Profile
or
®
™
®
service,
Dimensions and Specifications (in inches)
Outside Dimensions
The Insert Sleeve
The bottom edge of the insert sleeve has a 7/8" wide flange
on the sides and a 1/2" wide flange on the front and back.
Remote Location for the Control
The control may be removed from the hood and installed
into a wall or countertop. A 30-ft length of wire is supplied to
accommodate most installations. A blanking plate covers the
opening when the controls are removed. The overall size of
the control is 4-1/4" wide and 2-1/4" deep.
1-11/16"
We recommend that the cutout in granite or other hard
surfaces be made before the countertop is installed.
Specification Created 10/06
3-11/16"
130674
Related Manuals for GE 36" CUSTOM HOOD INSERT ZVC36LSS
Summary of Contents for GE 36" CUSTOM HOOD INSERT ZVC36LSS
-
Page 1: Outside Dimensions
ZVC36LSS GE Monogram 36" Custom Hood Insert ® Custom Insert Liner The custom canopy must be sized to fit the insert sleeve. Construct the canopy with an opening that is: 26"W x 13-3/16"D The opening must be constructed of 3/4" thick material to allow the sleeve locking clips to engage. - Page 2 ZVC36LSS GE Monogram 36" Custom Hood Insert ® Features and Benefits • Patented Installation Process - Makes the insert ideally suited to a wide variety of custom hood applications; with easy and secure connection to the ventilation duct • Single-Blower Ventilation with 640 CFM and 4 Fan...