HealthRider
Congratulations for
purchasing a state-of-
the-art HealthRider
®
chest pulse sensor.
The HealthRider
®
chest pulse sensor
is designed to contin-
uously monitor your
heart rate during your
workouts.
In addition, if you
have a HealthRider
®
Installation
The HealthRider
®
chest pulse sensor includes three
components: the chest strap, the sensor unit, and the
receiver module. Follow the steps below to install the
receiver module. A standard screwdriver (not included)
is required.
Using a standard screwdriver, pry the indicated
1
cap out of the console base. Discard the cap.
Console
Base
Cap
Chest Pulse Sensor
®
SOFTSTRIDER EX or SOFTSTRIDER PRO treadmill,
the chest pulse sensor adds two pulse programs to the
console.
The instructions in this guide explain how to install and
use the chest pulse sensor. Read this guide carefully
before using the chest pulse sensor.
If you have questions after reading this guide, call
our Customer Service Department toll-free at
1-800-999-3756, Monday through Friday, 6 am until
6 pm Mountain Time (excluding holidays). Please
mention model number HRMC09970 when calling.
Next, look into the opening in the console base
2
and locate the console wire harness. Plug the
receiver wire harness fully into the console wire
harness.
Console
Base
Receiver
Receiver
Wire
Module
Harness
Press the receiver module into the console base
until it snaps into place. Be careful to avoid pinch-
ing the wire harnesses.
Model No.
HRMC09970
Console
Wire
Harness