GE PHP900 Installation Instructions Manual
30" induction cooktop
Hide thumbs
Also See for PHP900:
- Owner's manual (72 pages) ,
- Technical service manual (35 pages) ,
- Installation instructions manual (11 pages)
Table of Contents
Available languages
Available languages
Quick Links
See also:
Owner's Manual, Technical & Service Manual
Installation
Instructions
30" Induction Cooktop
PHP900, ZHU30
I I-_
"If you have questions,
call 800.GE.CARES or visit our website at: De.tom"
"In Canada, call 800.561.3344
or visit our website at: geappliances.ca"
I
BEFORE YOU BEGIN
Read these instructions
completely
and carefully.
• IM PORTANT - save these i nstructions
for local inspector's
use
• IM PORTANT - Observe all g overning
codes and ordinances
° Note to Installer-
Be sure to leave these
instructions
with the Consumer.
° Note to Consumer-
Keep these instructions
for future reference.
° Product failure due to improper
installation
is
not covered under the Warrantu.
-&WARNING
-This
appliance
must be
properly
grounded.
• ATTENTION INSTALLER --ALL
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX.
A "PLUG AND RECEPTACLE" IS NOT PERMITTED
ON THESE PRODUCTS.
• Proper installation
is the responsibilitg
of the installer
and product
failure
due to
improper
installation
is NOT covered
under
warrants.
PARTS INCLUDED
i
i
Baffle
(For all installations
except
over an oven.)
Foam Tape
J
2 Hold-Down
Brackets
6 Hex-Head
Screws
2 Thumbscrews
MATERIALS YOU WILL NEED
Junction
Box
Large Size
(Sized for conduit
Wire Nuts
per local electrical
codes.)
3/4" Strain Relief
TOOLS YOU WILL NEED
Pencil
Phillips Head
Screwdriver
1/4" Nut Driver
Ruler or Straightedge
Safetg Glasses
SaberSaw
1/8" Drill Bit & Electric or
Hand Drill
31-10667
(06-07 JR)
1
Table of Contents
Related Manuals for GE PHP900
Summary of Contents for GE PHP900
- Page 1 Instructions PHP900, ZHU30 "In Canada, call 800.561.3344 or visit our website at: geappliances.ca" I I-_ "If you have questions, call 800.GE.CARES or visit our website at: De.tom" BEFORE YOU BEGIN MATERIALS YOU WILL NEED Read these instructions completely and carefully.
-
Page 2: Important Safety Instructions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY ELECTRICAL REQUIREM ENTS • For Personal Safetg, remove house fuse or open This appliance must be supplied with the proper circuit breaker before beginning installation. voltage and frequencg, and connected to an Failure to do so could result in serious injurg individual, properlg grounded... -
Page 3: Pre-Installation Checklist
Installation Instructions PRE-INSTALLATION CHECKLIST BEFORE YOU BEGIN ADVANCE PLANNING Combination Installations kWARNING - The electrical power to These cooktops may be installed in combination the cooktop supply line must be shut off while with an approved downdraft vent or a single oven. connections are being made. -
Page 4: Preparing The Opening
Installation Instructions PREPARING THE OPENING VERTICAL CLEARANCES (CONT.) The following HINIHUH clearance dimensions must be maintained. IMPORTANT: To ensure long life of the 13" MAX. Depth of uprotected 2" MIN. Clearance electronic components, allow a minimum overhead cabinets from cutout 12"... -
Page 5: Installing Option--For Ge Monogram
Installation Instructions INSTALLING OPTION--FOR GE MONOGRAM MONOGRAM INDUCTION COOKTOP COOKTOP REQUIREMENTS AND MONOGRAM DOWNDRAFT VENT The countertopmust have a deep flat surfaceto COMBINATION INSTALLATION ONLY. accommodate the cooktop and vent.Countertops with a rolled front edge and backsplash will not The installation... -
Page 6: Installing Options
Installation Instructions INSTALLING OPTIONS COOKTOP INSTALLATION OVER A POWER SUPPLY GE OR GE MONOGRAM SINGLE OVEN The oven requires a separate, properlg grounded 20 Amp, 3-wire 208 or 240 volt, 60 Hz power supplg. These cooktops may be installed over a single The cooktop requires a separate 40 Amp, 3-wire, oven. -
Page 7: Electrical Connections
Installation Instructions ELECTRICAL CONNECTIONS THREE-CONDUCTOR BRANCH CIRCUIT NEW CONSTRUCTION BRANCH CONNECTION CIRCUIT CONNECTION When connecting to a three-conductor branch circuit, if local codes permit: I A_I_W iAu mR iNuImNhGo uslempro pg rtc O2oppCet_ a. Connect the cooktop ground conductor lead eods can result in an electrical hazard or to the brach circuit ground using a wire nut. -
Page 8: Installing The Cooktop
Installation Instructions INSTALLING THE COOKTOP PROTECT SURFACE OF COOKTOP ATTACH FOAM TAPE Place a towel or tablecloth onto the countertop, Applg the foam tape around the outeredge of the Lag the cooktop upside down onto the protected glass. Do not overlap the foam tape. - Page 9 Installation Instructions I_1 INSERT COOKTOP INTO CUTOUT ATTACH HOLD-DOWN BRACKETS TO CABINET Insert the cooktop centered into the cutout opening. Make sure the front edge of the countertop Open the cabinet door. Install the second screw parallel to the cooktop. Make final check that all through the bracket and tighten.
-
Page 10: Operation Checklist
Installation Instructions CHECKLISTS PRE-TEST CHECKLIST OPERATION CHECKLIST Remove all items from the top Remove all protective film, if present, and any stickers. of the cooktop surface. Check to be sure thGt all wiring is secure and Turn on the power to the cooktop. not pinched or in contact with moving parts. -
Page 11
Instructions Table de cuisson induction de 30" d'installation PHP900, ZHU30 I r_ <
> AVANT DE COMMENCER I_QUIPEMENTS DONT VOUS AUREZ BESOIN Lisez attentivement la totalit_ de ces instructions. -
Page 12: Consignes De Securite Importantes
Instructions d'installation CONSIGNES DE SECURITE IMPORTANTES POUR VOTRE SI_CURITI_ CONDITIONS I_LECTRIQUES REQUISES • Pour votre s_curit_ personnelle, enlevez le fusible Cet appareil dolt @tre aliment@ avecla tension et la ou coupez le disjoncteur avant de commencer fr_quence correcte, branch_ sur un circuit d_riv_ individuel, correctement raccord_ 6 la terre, I'installation. - Page 13 Instructions d'installation CHECK-LIST DE PREPARATION PLANIFICATION AVANCI:!E AVANT DE COMMENCER AVERTISSEM ENT - L'alimentation Instelletions combin_es _lectrique de la table de cuisson doit _tre couple Ces tables de cuisson peuvent 6tre install_es en pour effectuer les raccordements. Le non-respect combinaison avec un extracteur agr_ ou un four...
- Page 14 Instructions d'installation PREPARATION DE L'OUVERTURE ESPACES LIBRES VERTICAUX (SUITE) L'espace libre doit avoir AU MINIMUM les dimensions suivantes. IMPORTANT : pour garantir la Iong6vit6 des 33 cm (13") MAX. de profondeur des 5 cm (2") MIN. composants 61ectroniques, laissez un espace placards sup6rieurs non prot6g_s d'espace libre sur la libre minimal de 30 cm (12") pour la circulation...
- Page 15 Instructions d'installation OPTION D'INSTALLATION--POUR GE MONOGRAM INSTALLATION COMBINF!E DE LA TABLE CONDITIONS REQUISES DU PLAN DE TRAVAIL DE CUISSON _, INDUCTION Le plan de travail dolt disposer d'une surface plate et MONOGRAM ET DE L'EXTRACTEUR profonde pour accepter I'installation de la table de cuisson et de I'extracteur.
-
Page 16: Options D'installation
I_LECTRIQUE CUISSON AU-DESSUS D'UN FOUR Le four n#cessite une alimentation ind#pendante, SIMPLE GE OU GE MONOGRAM correctement raccord#e 6 la terre de 20 amperes, 6 trois ills de 208/240 V CA, 60 Hz. La table de cuisson Ces tables de cuisson peuvent _tre install_es... -
Page 17: Branchements Electriques
Instructions d'installation BRANCHEMENTS ELECTRIQUES CONSTRUCTION NEUVE ET RACCORDEMENT AU CIRCUIT DI_RIVI_ A RACCORDEMENT AU CIRCUIT DI_RIVI_ TROIS CONDUCTEURS Lors du branchement _ un circuit d6riv_ _ trois conducteurs, si les normes locales le permettent A_ll ACVCEr RTleSn tSiEco_rrEcNT t :re_ n a. -
Page 18: Installation De La Table De Cuisson
Instructions d'installation INSTALLATION DE LA TABLE DE CUISSON FIXEZ L'ISOLANT ADHI]SIF F]-I PROTI:!GER LA SURFACE DE LA r]-i TABLE DE CUISSON Appliquez I'isolant adh6sif autour de la bordure ext6rieure de la vitre. Ne faites pas chevaucher Placez une serviette ou une nappe sur le plan de I'isolant adh_sif. - Page 19 Instructions d'installation I_1 INSISREZ LA TABLE DE CUISSON SERREZ LES FIXATIONS DE DANS LA DISCOUPE MAINTIEN AU MEUBLE Ins@ez la table de cuisson centr_e dans I'ouverture Ouvrez la porte du meuble. Installez la deuxi_me vis 6 travers la fixation et serrez. Puis, serrez la d_coup_e.
- Page 20 Instructions d'installation CHECK-LISTS CHECK-LIST DE PRI:!TEST CHECK-LIST DE FONCTIONNEMENT Enlevez la totalit_ du film protecteur, applicable, et tousles autocollants. Enlevez tousles objets de la surface de la table de cuisson. Assurez-vous que tout le cablage est bien fix_ sans pincement et qu'il n'est pas en contact Mettez sous tension la table de cuisson.
- Page 21 Instrucciones Anafe de inducci6n de 30" de instalaci6n PHP900, ZHU30 I[][] "Si tiene alguna pregunta, Ilame a 800.GE.CARES o visite nuestro sitio Web en: ge.com" ANTES DE COMENZAR MATERIALES NECESARIOS Lea estas instrucciones por completo g con detenimiento. • IM PORTANTE - Guarde estas...
-
Page 22: Instrucciones De Seguridad Importantes
Instrucciones de instalaci6n INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD REQUERIMIENTOS ELI_CTRICOS • Para seguridad personal, quite los fusibles o abra Este artefacto debe abastecerse con el voltaje g el disguntor antes de comenzar la instalaci6n, frecuencia adecuados g debe conectarse en un circuito derivado individual... -
Page 23: Antes De Comenzar
Instrucciones de instalaci6n LISTA DE CONTROL PRE-INSTALACION PLANIFICACI6N PREVIA ANTES DE COMENZAR Instalaciones en combinaci6n ADVERTENCIA - La energia el_ctrica Estosanafes pueden instalarse en combinaci6n de la linea de abastecimiento del anafe debe con una ventilaci6n de corriente descendente estar desconectada mientras se realizan aprobada o un homo Qnico. - Page 24 Instrucciones de instalaci6n COMO PREPARAR LA ABERTURA r]-i ESPACIOS LIBRES VERTICALES Deben mantenerse las siguientes dimensiones (CONT.) MiNIMAS de espacio libre. 13" de profundidad MAX en 2" de espacio libre IMPORTANTE: Para garantizar una larga vida gabinetes a6reos sin protecci6n MiN desde el carte ,a taap re Otil de los componentes...
- Page 25 Instrucciones de instalaci6n • OPCION DE INSTALACION--PARA EL GE MONOGRAM S6LO PARA LA INSTALACI6N REQUERIHIENTOS DEL ANAFE COMBINACI6N DE ANAFE DE La mesada debe contar con una superficie plana g INDUCCI6N MONOGRAM profunda para que entren el anafe g la ventilaci6n.
- Page 26 OPCIONES DE INSTALACION INSTALACI6N DEL ANAFE SOBRE UN SUMINISTRO DE ENERGJA HORNO GE O UN HORNO UNICO GE El horno requiere un suministro de energfa individual MONOGRAM con adecuada conexi6n a tierra de 20 amperios, tres hilos 208 o 240 voltios, g 60 hercios. El anafe requiere...
- Page 27 Instrucciones de instalaci6n CONE×IONES ELECTRICAS CONEXleN DE CONSTRUCCION NUEVA CONEXleN DE CIRCUITO DERIVADO DE V DE CIRCUITO DERIVADO TRES CONDUCTORES Cuando conecte un circuito derivado de tres ADVERTENCIA: unacone×i6n conductores, si Io permiten los c6digos locales: a. Conecte el cable de conductor a tierra inadecuada de cableado dom6stico de Ill luminia con cables de cobre puede generar...
- Page 28 Instrucciones de instalaci6n COMO INSTALAR EL ANAFE IT1 PROTEJA LA SUPERFICIE DEL ANAFE COLOQUE CINTA DE ESPUMA Aplique la cinta de espuma alrededor de los Coloque una toalla o mantel sobre la mesada. extremos exteriores del vidrio. No superponga la Deposite el anafe dado vuelta sobre la superficie cinta de espuma.
- Page 29 Instrucciones de instalaci6n E_ INTRODUZCA EL ANAFE EN LA I-_ CONECTE LOS SOPORTES DE SUJECION AL GABINETE ABERTURA Abra la puerta del gabinete. Instale el segundo Coloque elanafe centrado dentrode laabertura tornillo a trav@s del soporte g ajuste. Luego ajuste cortada, AsegQrese de que elextremo frontal d e la el primer tornillo.
-
Page 30: Listas De Control
Instrucciones de instalaci6n LISTAS DE CONTROL LISTA DE CONTROL PREVIA A LA LISTA DE CONTROL DE PRUEBA FUNCIONAMIENTO Quite toda la pelicula protectora, si la hubiera, Quite todos los elementos de la superficie anafe. g todos los autoadhesivos, Verifique que todo el cableado est_ seguro g Conecte la energfa del anafe. - Page 31 Instrucciones de instalaci6n NOTAS...
- Page 32 Instrucciones de instalaci6n NOTAS...