GE AEQ24 Owner's Manual And Installation Instructions page 5
Room air conditioner
Hide thumbs
Also See for AEQ24:
- Owner's manual (60 pages) ,
- Owner's manual & installation instructions (56 pages) ,
- Owner's manual and installation instructions (56 pages)
Table of Contents
Available languages
Available languages
GEAppliances.com
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote
Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
The remote control signal has a range of
up to 20 feet.
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
Cool Mode
Use the Cool mode at Low, Mad, High or Auto Fan
Speed for cooling. Usethe Temperature Increase A
/ Decrease T pads to set the desired temperature
between 64% and 86% in I°F increments.
An electronic thermostat is usedto maintain the room
temperature. The compressor will cycle on
and off to keep the room at the set levelof comfort.
Setthe thermostat at a lower number and the indoor
air will become cooler. Setthe thermostat at a higher
number and the indoor air will become warmer.
NOTE:If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan
setting to a Cool setting, it may take approximately
5 minutes for the compressor to start and cooling to
begin.
Cooling Descriptions
For Normal Cooling-Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling--Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling-Select the
Cool mode and Low fan with a middle set
temperature.
Energy Saver Mode
Controls the fan.
ON--The fan will cycle on and off with the
compressor. This results in wider variations of room
temperature and humidity. Normally used when the
room is unoccupied. NOTE:Thefan may continue to
run for a short time after the compressor cycles off.
OFF--The fan runs all the time, while the compressor
cycles on and off.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan
speed to provide air circulation and filtering without
cooling. Sincefan-only settings do not provide
cooling, a Set temperature cannot be entered. The
room temperature will appear
in the display.
NOTE:Auto FanSpeed cannot be used when in the
Fen Only Mode.
Auto Fan Speed
Set to Auto fun speed for the fan speed to
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needs more cooling, the fan speed
will automatically increase. If the room needs less
cooling, the fan speed will automatically decrease.
NOTE:Auto Fan Speedcannot be used when in the
Fen Only Mode.
Power
Outage
Recovery
Feature
In the case of a power outage or interruption, the
unit will automatically restart in the settings last
used after the power is restored. If the Delay 1-24hr
feature was set, it will resume countdown. You may
need to set a new time if desired.
Chapters
Table of Contents
