Oven Light Replacement; Model - GE Appliances P2B930 Owner's Manual And Installation Instructions
Self-cleaning dual fuel convection ranges
Hide thumbs
Also See for Appliances P2B930:
- Owner's manual and installation instructions (120 pages) ,
- Owner's manual & installation instructions (64 pages) ,
- Technical service manual (76 pages)
Table of Contents
Available languages
Available languages
Care and cleaning of the range,
iA
i
,-,WARNING
I Shock
or
Burn Hazard: Before replacing oven light bulb, disconnect the electrical power to the
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
Oven Light Replacement
(on some models)
Be sure to let the light cover and bulb cool
completely.
To remove the coven
To replace the coven
[7]
Line up tabs of lens in front of tabs on
housing and rotate clockwise to engage.
r_
Twist lens counterclockwise about a
quarter turn to remove.
Do not remove any screws to remove the cover.
[]
Replace bulb with a 40-watt appliance
bulb or two-prong halogen bulb, as
appropriate.
The storage drawer may be
removed for cleaning under the
range.
Removable
Storage
Drawer
(on some models)
Thestorage drawer is a good place to store
cookware and bakeware. Do not store plastics
and flammable material in the drawer.
The storage drawer may be removed
for cleaning under the range. Cleanthe storage
drawer with a damp cloth or sponge. Never use
harsh abrasives or scouring pads.Toremove
storage drawer:
r-f] Pulldrawer straight out until it stops.
Tilt the front of the drawer up and free of
the range.
To replace storage drawer:
I-f] Set the stops on the back of the drawer
over the stops in the range.
[_
Slide drawer evenly and straight back, so
that the rails in the range are engaged.
Removable
Drawer
(Warming Drawer Models only)
NOTE: Formodels with an electric warming
drawer, before performing any adjustments,
cleaning or service, disconnect the range
electrical power supply at the household
distribution panel by removing the fuse or
switching off the circuit breaker. Hake sure
the warming drawer heating element is cool.
Host cleaning can be done with the drawer in
place. However, the drawer may be removed if
further cleaning is needed. Use soup and warm
water to thoroughly clean.
To remove the drawer'.
To replace the drawer'.
[-_
Place the left drawer rail around the inner
left rail guide and slide it in
slightly to hook it.
[]
Placethe right drawer rail around the inner
right rail guide and slide it in slightly to
hook it.
r_
Slide the drawer all the way in.
Z]
Pullthe drawer straight out until
it stops.
Pressthe left rail release up and press the
_Le_J
right rail release down, while pulling the
drawer forward and free.
36
Table of Contents
