HP StorageWorks MSA 2/8 - SAN Switch Reference Manual page 538
Hp storageworks fabric os v3.1.x/4.1.x reference guide (aa-rs24c-te, june 2003)
Hide thumbs
Also See for StorageWorks MSA 2/8 - SAN Switch:
- Reference manual (394 pages) ,
- User manual (270 pages) ,
- Installation manual (72 pages)
Table of Contents
Fabric OS Commands
Operands
This command has the following operands:
slotnumber
(V4.1.x only)
portnumber
mode
Example
The following example configures blade 2 port 3 as a locked G_Port:
switch:admin> portCfgGport 2/3, 1
done.
See Also
configure
portCfgShow
portShow
switchShow
538
Specify the slot number for a StorageWorks Core
switch. For all other switches this operand is not
required. The slot number must be followed by a slash
( / ) and the port number, so that each port is
represented by both slot number (1 through 4, or 7
through 10), and port number (0 through 15).
The StorageWorks Core switch has a total of 1–10
slots. Slot number 5 and 6 are control processor cards,
and slot 1 through 4, and 7 through 10, are port
cards. On each port card, there are 16 ports counted
from the bottom, 0 to 15.
Specify a port number. Valid values for port number
vary depending on the switch type. This operand is
required.
Specify a value of 1 to designate the port as a G_Port
or specify a value of 0 to remove the G_Port
designation from the port. A value of 0 is the default
port state. This operand is required.
Fabric OS Version 3.1.x/4.1.x Reference Guide
Table of Contents
