Configuring Ports In The S/390 Mode; Configure Ports Dialog Box (S/390 Mode) - HP StorageWorks 2/140 - Director Switch Product Manager Manual
Director product manager user guide
Hide thumbs
Also See for StorageWorks 2/140 - Director Switch:
- Service manual (396 pages) ,
- Installation manual (128 pages) ,
- Release note (27 pages)
Table of Contents
Configuring the Director
NOTE: Note that your director model, firmware, and port card may not allow 2 Gb/sec data
speeds.
9. Click the Bound WWN field, and type the WWN or nickname of the specific
device to be connected to the port.
10. Use the scroll bar on the right side of the Configure Ports dialog box table to
display additional ports that you want to configure.
11. Click Activate to activate the changes and close the dialog box.
12. If you are finished configuring the switch, back up the configuration data. For
more information, refer to
page
3–36.
Configuring Ports in the S/390 Mode
To configure ports in S/390 mode, use the following steps:
NOTE: You cannot configure port names in the Configure Ports dialog box in S/390 mode.
Use the Configure Addresses - "Active" dialog box.
1. Choose Ports from the Configure menu on the menu bar. The Configure Ports
dialog box displays, as shown in
Figure 3–6: Configure Ports dialog box (S/390 Mode)
Ports are numbered from 0-63 on the Director 2/64, and 0-127 and 132-143 on the
Director 2/140. Note that for the Director 2/140, ports 128-131 are internal ports
and not available for external connections.
3–16
"Backing Up and Restoring Configuration
Figure
3–6.
director product manager user guide
Data" on
Table of Contents
