Table of Contents
If the print server is not able to connect to the network through auto-negotiation, you can set the link
setting through one of the following methods:
●
the printer's control panel (if it has one).
●
the embedded Web server through a Web browser.
●
the print server's Telnet interface through a system command prompt.
●
a TFTP (Trivial File Transfer Protocol) configuration file that is downloaded, for example, from a
BootP or DHCP server.
●
network management tools, such as HP Web Jetadmin.
Resetting to Factory Defaults
Parameters on the HP Jetdirect print server (for example, the IP address) can be reset to factory
default values using the following procedures:
CAUTION:
factory default values. However, a Certificate Authority (CA) certificate that has been installed by the
user to validate a network authentication server will not be saved.
●
HP LaserJet Printer/MFP with EIO Print Server
In most cases, the HP Jetdirect EIO print server can be reset to factory defaults when a cold-
reset is performed on the printer.
CAUTION:
Resetting the printer will clear all data from the printer memory and reset all printer settings,
including network configurations, to their factory default values. After a cold reset, users may be
affected due to changes in user-specified printer settings. Network systems may lose their
connection to the printer.
NOTE:
reset the HP Jetdirect print server.
◦
For legacy HP LaserJet printers, a cold-reset is performed by turning the printer on while
pressing the Go, Start, or Pause/Resume button at the control panel.
◦
For recent LaserJet printers and MFPs, use the printer's Service menu accessed during the
initial power-on sequence. See
◦
For other printers/MFPs, refer to the manuals for those devices. In addition, visit
http://www.hp.com/go/support
information.
NOTE:
values have been assigned.
ENWW
A factory-installed HP Jetdirect X.509 certificate will be saved over a cold reset to
Be sure to print an HP Jetdirect configuration page before performing a cold reset.
The Restore Factory Settings menu item in the device control panel menu will not
After a cold reset, print an HP Jetdirect configuration page to confirm that factory-reset
Service Menu Example on page
and search for document file bpj02300.html for more
20.
Resetting to Factory Defaults
19
Table of Contents
Troubleshooting
