Figure 1-3. External Connections To The Server - HP A4500A - VMEbus Single Board Computer 744 Motherboard Manual
Basic cable connections
Hide thumbs
Also See for A4500A - VMEbus Single Board Computer 744 Motherboard:
- Hardware manual (202 pages) ,
- Manual (114 pages) ,
- Programmer's manual (109 pages)
Table of Contents
The graphic shown below illustrates locations of the external connections to the server.
Figure 1-3
External Connections to the Server
100-240V~, 600W
6.0-2.6A, 50-60Hz
On/Off
Switch
100-240V~, 600W
6.0-2.6A, 50-60Hz
Ultra 2 W ide SCSI
Path: 0/0/1/ 0
Ultra2 Wide SCSI
Path: 0/0/1/0
A
B
ccrr008
Connect External Small Computer System Interface (SCSI) Devices
Connect external SCSI devices to the single ended SCSI bus (labeled: Narrow Single-Ended SCSI Path:
0/0/2/0) on the system card or to the Ultra 2 SCSI bus (labeled: Ultra 2 SCSI Path: 0/0/1/0).
Ensure that all devices on the SCSI bus have a unique address and the last device is terminated. Refer to the
documentation accompanying each device to learn how to set addresses and where to place terminators.
Connect a System Console
For more information on console configuration, refer to the rp24xx Hardware Manual (search
NOTE
on rp2400) at http://docs.hp.com.
•
Using the ASCII Terminal as a System Console. If an ASCII terminal is to be used as a console/UPS
port, make sure that the keyboard is connected and a power cable is available.
•
Using a Secure Web Console PCI card as a System Console. If the Secure Web Console PCI card is
to be used as a system console, first configure the Guardian Service Processor (GSP). For more
information on GSP configuration, refer to the rp24xx Hardware Manual (search on rp2400) at
http://docs.hp.com.
Then, connect an RJ45 LAN cable to the Secure Web Console PCI card installed in an I/O card slot on the
back of the server.
Chapter 1
GSP Reset
TOC
GSP Reset TO C
A
B
Narro w S ingle Ended SCSI
10/100BASE- T
Path: 0/0/2/ 0
Path: 0/0/0/ 0
Narrow Single
Ended SCSI
Path: 0/0/2/0
10/100BASE-T
Path: 0/0/0/0
HP rp2400 Series of Servers - Basic Cable Connections
win
Path: 0/2/0
urbo
Console/
UPS Port
10BASE- T
Console/
LAN Consol e
UPS Por t
Path: 0/6/2
10BASE-T
LAN Console
Front Panel Controls and indicators
win
Path: 0/4/0
urbo
wi n
Path: 0/2/0
wi n
Path: 0/4/0
urbo
urbo
Path: 0/6/2
Path: 0/6/0
Path: 0/6/0
Pull-Out
Tab
9
Table of Contents
