HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual

Basic Cable Connections - HP rp2400 Series of Servers - Document Changes

The document Basic Cable Connections - HP rp2400 Series of Servers has been revised. See the table below.

IMPORTANT The latest versions of these documents, and any updates to these documents, are posted under

the appropriate server at http://docs.hp.com.

Ver. 1.0

Ver. 2.0

Page #

Page #

2

2

3

7

4

8

5

9

6

10

6

10

v1

Printed in the U.S.A.

Send documentation comments to http://docs.hp.com/assistance/index.html.

For detailed installation, maintenance, and technical information, refer to the

rp24xx Hardware Manual and other documentation (search on rp2400) at

http://docs.hp.com.

2. (Amber) Attention (ATTN) LED - When lit, indicates that a condition exists that

requires operator attention and assistance from HP Support.

NOTE: For technical support please call your local support hotline or contact HP

at http://www.hp.com/support.

NOTE: For more information on console configuration, refer to the rp24xx

Hardware Manual (search on rp2400) at http://docs.hp.com.

Using a Secure Web Console PCI card as a System Console. If the Secure

Web Console PCI card is to be used as a system console, first configure the

Guardian Service Processor (GSP). For more information on GSP configuration,

refer to the rp24xx Hardware Manual (search on rp2400) at http://docs.hp.com.

Then, connect an RJ45 LAN cable to the Secure Web Console PCI card installed

in an I/O card slot on the back of the server.

Using the LAN Console as a System Console. If a LAN Console is to be used

as a system console, first configure the Guardian Service Processor (GSP). For

more information on GSP configuration, refer to the rp24xx Hardware Manual

(search on rp2400) at http://docs.hp.com.

Then, connect it to the system with an RJ45 LAN cable to the RJ45 connector

labeled 10BASE-T LAN Console connection on the back of the server.

NOTE: [regarding connecting Power Distribution Units (PDUs) to Dedicated AC

Input Receptacles] Current requirements vary with input voltage, server

configuration, and number of power supplies installed. Refer to "System Site

Preparation" in the rp24xx Hardware Manual at http://docs.hp.com.

Description of Change

rp24xx_cable_change_list