Cisco 6509 - Catalyst Chassis Switch Installation Manual page 33

Installation guide
Table of Contents
Chapter 1
Product Overview
Table 1-3
Catalyst 6503-E Switch Features (continued)
Feature
Fan Tray
Power Entry Module (PEM)
Power Supplies
1. PEMs are required for Catalyst 6503 and Catalyst 6503-E switches only.
OL-5781-04
Description
Supports one hot-swappable fan tray. These fan tray models are
supported:
WS-C6503-E-FAN—282 CFM
Note
The fan tray contains four individual fans. The individual fans
are not field replaceable. You must replace the fan tray.
Fan tray STATUS LED
Red—One or more individual fans have failed.
Green—Fan tray is operating normally.
1
A PEM is required for each installed power supply.
PEM-15A-AC (PEM for 950 W AC-input power supplies).
PEM-DC/3 (PEM for 950 W DC-input power supplies).
PEM-20A-AC+ (PEM for 1400 W AC-input power supplies).
Supports one or two power supplies. The following power supplies are
supported:
PWR-950-AC (950 W AC-input power supply).
PWR-950-DC (950 W DC-input power supply).
PWR-1400-AC (1400 W AC-input power supply).
Installed power supplies can be of different wattage ratings. Installed
power supplies can be both AC-input, both DC-input, or one AC-input
and one DC-input. Power supplies can be configured in either redundant
or non-redundant mode.
All Catalyst 6500 series AC-input power supplies require single-phase
source AC. Source AC can be out of phase between multiple power
supplies or multiple AC-power plugs on the same power supply because
all AC power supply inputs are isolated.
Single power supplies are installed in the lower power supply bay. The
second power supply is installed in the upper power supply bay.
Catalyst 6500 Series Switches Installation Guide
Catalyst 6503-E Switch
1-9

Hide quick links:

Table of Contents
loading

This manual is also suitable for:

Ws-c6506Catalyst 6500 series

Table of Contents