System Management; Computer Setup (F10) Utility - HP Xw9400 - Workstation - 16 GB RAM Reference Manual
Hp xw9400 workstation - service and technical reference guide
Hide thumbs
Also See for Xw9400 - Workstation - 16 GB RAM:
- Installation manual (9 pages) ,
- Declaration of conformity (1 page) ,
- User manual (155 pages)
Table of Contents
4
System management
This section describes the various tools and utilities that allow for the system management of the
workstation.
●
Computer Setup (F10) Utility on page 25
●
Desktop management on page 36
Computer Setup (F10) Utility
The Computer Setup Utility enables you to:
●
Change current settings from the factory default settings.
●
Modify or restore factory default settings.
●
Determine if all of the devices installed on the workstation are recognized by the system and
functioning properly.
●
Determine information about the operating environment of the workstation.
●
Solve system configuration errors detected but not automatically fixed during the Power-On Self-
Test (POST).
●
Establish and manage security features and password prompting during system reset and during
power-on.
●
Establish and manage energy-saving time-outs (not supported for Linux platforms).
●
Set the system date and time.
●
Set, view, and change the system configuration, including settings for processor, graphics,
memory, audio, storage, communications, and input devices.
●
Modify the boot order of installed mass storage devices such as hard drives, diskette drives, optical
drives, and network drives.
●
Enable or disable Network Server Mode, which enables the workstation to boot the operating
system when the power-on password is enabled with or without a keyboard or mouse attached.
When attached to the system, the keyboard and mouse remain locked until the power-on password
is entered.
●
Enable/disable POST Messages to change the display status of POST messages. POST
messages disabled suppresses most POST messages, such as memory count, product name, and
other non-error text messages. If a POST error occurs, the error is displayed regardless of the
mode selected. To temporarily switch to POST messages enabled, press any key (except F1
through F12) during POST.
●
Establish an Ownership Tag, the text of which is displayed each time the system is turned on or
restarted.
●
Enter the Asset Tag or property identification number assigned by your company to this
workstation.
ENWW
Computer Setup (F10) Utility
25
- Quick Links:
- Product Features
- Exploded View
Hide quick links:
Table of Contents
Troubleshooting
