Configuring Fcip Tape Acceleration - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 41-1
Host
Host 1
Host 2
Table 41-2
Table 41-2
Host
Host 1
Host 2
Another example setup is when a tape drive is shared by multiple hosts through a single tape port. For
instance, Host 1 has access to Drive1 and Drive2, and Host 2 has access to Drive 2, Drive 3, and Drive
4. A correct LUN mapping configuration for such a setup is shown in
Table 41-3
Host
Host 1
Host 2
Configuring FCIP Tape Acceleration
To enable FCIP tape acceleration, follow these steps:
Command
Step 1
switch1# config terminal
switch(config)#
Step 2
switch1(config)# interface fcip 5
switch1(config-if)#
Cisco MDS 9000 Family CLI Configuration Guide
41-34
Correct LUN Mapping Example with Single Host Access
LUN Mapping
LUN 1
LUN 2
LUN 3
LUN 4
describes incorrect tape library LUN mapping.
Incorrect LUN Mapping Example with Single Hosts Access
LUN Mapping
LUN 1
LUN 2
LUN 1
LUN 2
Correct LUN Mapping Example with Multiple Host Access
LUN Mapping
LUN 1
LUN 2
LUN 2
LUN 3
LUN 4
Drive
Drive 1
Drive 2
Drive 3
Drive 4
Drive
Drive 1
Drive 2
Drive 3
Drive 4
Table
Drive
Drive 1
Drive 2
Drive 2
Drive 3
Drive 4
Purpose
Enters configuration mode.
Creates an FCIP interface (5).
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 41
Configuring FCIP
41-3.
Hide quick links:
Table of Contents
Troubleshooting
