Creating Fcip Links - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Example 41-2 Displays the Specified FCIP Profile Information
switch# show fcip profile 7
FCIP Profile 7
Creating FCIP Links
When two FCIP link endpoints are created, an FCIP link is established between the two IPS modules or
MPS-14/2 modules. To create an FCIP link, assign a profile to the FCIP interface and configure the peer
information. The peer IP switch information initiates (creates) an FCIP link to that peer switch (see
Figure
Figure 41-10
Connecting switch (peer) = 10.1.1.1
IP address of Gigabit Ethernet
interface 3/1 = 10.100.1.25
Cisco MDS 9000 Family CLI Configuration Guide
41-10
Internet Address is 47.1.1.2 (interface GigabitEthernet4/7)
Listen Port is 3225
TCP parameters
SACK is disabled
PMTU discovery is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 300 ms
Maximum number of re-transmissions is 4
Send buffer size is 0 KB
Maximum allowed bandwidth is 1000000 kbps
Minimum available bandwidth is 15000 kbps
Estimated round trip time is 1000 usec
41-10).
Assigning Profiles to Each Gigabit Ethernet Interface
Endpoint
Interface FCIP = 51
Profile = 10
Switch 1
FCIP link
Switch 1
IP router
Endpoint
Interface FCIP = 52
Profile = 20
Connecting switch (peer) = 10.100.1.25
Virtual (E) ISL
IP router
IP
network
IP address of Gigabit Ethernet
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 41
Configuring FCIP
Switch 2
Switch 2
interface 3/1 = 10.1.1.1
Hide quick links:
Table of Contents
Troubleshooting
