Managing The Call Home Database - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual
Fibre channel switch
Hide thumbs
Also See for AK241A - StorageWorks 8Gb Simple SAN Connection:
- Cli manual (270 pages) ,
- Cli manual (320 pages) ,
- Installation and reference manual (82 pages)
Table of Contents
To display the Call Home service configuration, enter the show setup callhome command, as shown
in the following example.
8/20q FC Switch (admin) #> show setup callhome
Callhome Information
--------------------
PrimarySMTPServerAddr
PrimarySMTPServerPort
PrimarySMTPServerEnabled
SecondarySMTPServerAddr
SecondarySMTPServerPort
SecondarySMTPServerEnabled
ContactEmailAddress
PhoneNumber
StreetAddress
FromEmailAddress
ReplyToEmailAddress
ThrottleDupsEnabled
+ indicates active SMTP server
Managing the Call Home database
To modify the Call Home database:
1.
Open an Admin session with the admin start command. An Admin session prevents other accounts
from making changes at the same time through Telnet, QuickTools, Simple SAN Connection Manager,
or any other management application.
8/20q FC Switch #> admin start
2.
Open a Callhome Edit session with the callhome edit command. The Callhome Edit session
provides access to the profile, callhome, and capture commands that are used to make
modifications to the Call Home database.
8/20q FC Switch (admin) #> callhome edit
8/20q FC Switch (admin-callhome)#> callhome . . .
8/20q FC Switch (admin-callhome)#> profile . . .
8/20q FC Switch (admin-callhome)#> capture . . .
3.
When you finish making changes, take one of the following actions:
• To save the changes and close the Callhome Edit session, enter the callhome save command.
Changes take effect immediately.
8/20q FC Switch (admin-callhome)#> callhome save
• To close the Callhome Edit session without saving changes, enter the callhome cancel
command.
8/20q FC Switch (admin-callhome)#> callhome cancel
4.
To release the Admin session for other administrators, enter the admin end command.
To remove all Call Home profiles and restore the Call Home service configuration to its factory state, enter
the reset callhome command.
8/20q FC Switch (admin) #> reset callhome
0.0.0.0
25
False
0.0.0.0
25
False
True
8/20q Fibre Channel Switch command line interface guide 115
Table of Contents
