Removing The Wwn Bezel (Logo Plate) And Wwn Card; Wwn Card Related System Log Messages - HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual
Hp storageworks dc and dc04 san backbone director switches hardware reference guide (5697-7814, february 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- User manual (248 pages) ,
- Release note (76 pages)
Table of Contents
3.
Check the error message indicating the status of the WWN unit (see
Type the chassisShow command to determine the status of the WWN unit.
Table 38 WWN card related system log messages
Type of message
WWN unit removal was detected
WWN unit insertion was detected
WWN unit fails to power on
WWN unit is being faulted
Removing the WWN bezel (logo plate) and WWN card
To remove the WWN bezel and WWN card:
CAUTION:
Wear a grounded ESD strap when handling the WWN card. Use the grounding connections above
the power connectors on the chassis.
1.
Open a Telnet session to the DC04 SAN Director and log in to the active CP as admin. The
default password is password.
2.
Verify that you are logged into the active CP. Run the haShow command to determine the active
CP.
3.
Remove the two screws from the WWN bezel. Pull the bezel away from the chassis and set it
aside. The WWN cards and their status LEDs are visible. See
4.
Type fruReplace wwn from the active CP blade and wait for the phrase Do you wish to
continue [y/n]? to be displayed, and then type y.
System message (errshow or errdump)
INFO, , FRU WWN # removal detected.
INFO, , FRU WWN # insertion detec-
ted.
CRITICAL, , WWN # failed to power
on
ROR, , WWN # set to faulty,
rc=
HP StorageWorks DC and DC04 SAN Backbone Director Switches
Table
38).
Figure 72
189
Table of Contents
