Tunnel Source - Dell PowerConnect 5424 Command Line Interface Manual
Powerconnect 5400 series
Hide thumbs
Also See for PowerConnect 5424:
- Getting started manual (222 pages) ,
- User manual (444 pages) ,
- User manual (416 pages)
Table of Contents
User Guidelines
•
The ipv6 tunnel routers-dns command determines the string that the host uses for automatic tunnel
router lookup in IPv4 DNS procedure. By default, the string 'ISATAP' is used for the corresponding
automatic tunnel types.
•
Per tunnel only one string can represent the automatic tunnel router name. Using this command
overwrites the existing entry.
Example
The following example configures a global string "Dell_Tunnel_Router" to represent a specific automatic
tunnel router domain name..
Console (config)# interface tunnel 1
Console (config-tunnel)# tunnel isatap router Dell_Tunnel_Router
tunnel source
The tunnel source Interface Tunnel Configuration mode command sets the local (source) tunnel
interface IPv4 address. Use the no form to delete the tunnel local address.
Syntax
•
tunnel source { auto | ip-address ipv4-address}
•
no tunnel source
•
auto — The system minimum IPv4 address is used as the source address for packets sent on the
tunnel interface. If the IPv4 address is changed then the local address of the tunnel interface is
also changed.
•
ip4-address — Pv4 address to use as the source address for packets sent on the tunnel interface.
The tunnel interface local address is not changed when the IPv4 address is moved to another
interface.
Default Configuration
No source address is defined.
Command Mode
Interface Tunnel Configuration mode.
User Guidelines
•
The configured source IPv4 address is used for forming the tunnel interface identifier. The interface
identifier is set to the 8 least significant bytes of the SIP field of the encapsulated IPv6 tunneled
packets.
435
Tunnel
- Quick Links:
- Cli Command Modes
- Starting the Cli
Hide quick links:
Table of Contents
