Cisco AIR-BR1410A-A-K9 - Aironet 1410 Wireless Bridge Deployment Manual page 13

VLAN 12

Station_B

Station_C

VLAN 14

Infrastructure ssid: native VLAN

VLAN CONFIGURATION

Figure 8.

The main steps to configure the VLANs are:

1) Enable 802.1q trunking on the wired network: On either side of the Link you should console into

the Ethernet port of the Switch to which Bridge is connected and give the following commands:

Interface FastEthernet0/1

Switchport trunk encapsulation dot1q

Switchport mode trunk

Please note that you must have 100 Mbps Ethernet connections between the switch and

the Bridge.

2) Enable 802.1q trunking on the Bridges: Specify the VLAN-id X as the native VLAN on the

root and non root bridges by going into the GUI services and clicking on VLAN.

Copyright © 2004 Cisco Systems, Inc. All rights reserved.

Station_A

VLAN 11

Root

Switch_1

802.1Q Trunk

100Mbps,

NATIVE VLAN

Page 13 of 53

VLAN 11

Non-Root

Switch_2

Station_E

VLAN 12

Station_

D