Page Edge Filler (Adf) - Fujitsu 5900C - fi - Document Scanner Operator's Manual
Image scanner
Hide thumbs
Also See for 5900C - fi - Document Scanner:
- Getting started (30 pages) ,
- Brochure & specs (2 pages) ,
- Supplementary manual (4 pages)
Table of Contents
8.5 Page Edge Filler (ADF)
Depending on the state of the documents, the shadow of the scanned document appears in the end portion
of the output image and black thin lines may be generated.
If this is the case, you can improve the output image by using the "Page Edge Filler" function. This func-
tion fills the end portion of the image so that it looks clean.
Configure the settings for the Page Edge Filler as follows:
1.
Start up the Software Operation Panel.
Refer to
"8.1 Scanner Settings" on page
2.
Select the "Page Edge Filler (ADF)" setting on the [Device Setting 2] tab.
3.
Specify the length for each end section; top, bottom, right, and left, to fill
the end sections.
L
The specified areas are filled with white when the backing (background) is white, and with
black when the backing is black.
166.
T
T : Top edge = 0 ~ 15 mm
D : Bottom edge = -7 ~ 7 mm
R : Right edge = 0 ~ 15 mm
Generated
L : Left edge = 0 ~ 15 mm
R
(can be set in increments of 1mm)
image
Filled area
D
8.5 Page Edge Filler (ADF)
8
179
Table of Contents
