Enable Raid Controller Module Data Transfer; Enable Storage Array Feature - Dell PowerVault MD3260 Cli Manual
Powervault modular disk storage arrays
Hide thumbs
Also See for PowerVault MD3260:
- Owner's manual (58 pages) ,
- Deployment manual (26 pages) ,
- Configuration manual (17 pages)
Table of Contents
Parameter
diskPool
Notes
All of the physical disks that comprise the disk pool must be security capable.
Enable RAID Controller Module Data Transfer
This command revives a RAID controller module that quiesces while running diagnostics.
Syntax
enable controller [(0 | 1)] dataTransfer
Parameter
Parameter
controller
Enable Storage Array Feature
This command enables a premium feature using a feature key file.
Syntax
enable storageArray [featurePack | feature]
file="filename"
Parameter
Parameter
file
Additional Information
A feature pack is a predefined set of premium features, such as Storage Partitioning and Remote Replication. These
premium features are combined for the convenience of the users.
A premium feature is an additional application to enhance the capabilities of a storage array.
NOTE: Before you enable the High Performance Tier premium feature, stop all host I/O operations to the storage
array. When you enable the High Performance Tier premium feature, both RAID controller modules in the storage
array immediately reboot.
Description
The alphanumeric identifier (including - and _) of the disk
pool that you want to place in the Security Enabled state.
Enclose the disk pool identifier in square brackets ([ ]).
Description
RAID controller module that you want to revive. Valid RAID
controller module identifier values are 0 and 1. The
identifier value is 0 for the RAID controller module on the
top and 1 for the RAID controller module on the bottom
when viewed from the rear of the enclosure. You must put
brackets ([ ]) around the RAID controller module identifier.
If you do not specify a RAID controller module, the storage
management software returns a syntax error.
Description
File path and file name of a valid feature key file. Valid file
names for feature key files must end with a .key extension.
You must put quotation marks (" ") around the file path and
file name.
143
- Quick Links:
- How to Use the Command Line...
- Cli Commands
Hide quick links:
Table of Contents
