Set Expander-Fault-Isolation; Set Expander-Phy; Set Led - HP 2000fc Cli Reference Manual
Modular smart array
Hide thumbs
Also See for 2000fc:
- Reference manual (330 pages) ,
- User manual (150 pages) ,
- Specification sheet (26 pages)
Table of Contents
set expander-fault-isolation
When fault isolation is enabled, the Expander Controller will isolate PHYs that fail
to meet certain criteria. When fault isolation is disabled, the errors are noted in the
logs but the PHYs are not isolated.
Note –
advice of a service technician.
For details see "set expander-fault-isolation" on page 125.
set expander-phy
The Expander Controller will enable or disable (isolate) the a specific PHY.
Note –
advice of a service technician.
For details see "set expander-phy" on page 127.
set led
Changes the state of drive module or enclosure LEDs to help you locate devices.
For a drive module, the top LED will illuminate solid blue. For an enclosure, the top
LED on the chassis ear will illuminate solid blue .
For details see "set led" on page 138.
This command should be used only by service technicians, or with the
This command should be used only by service technicians, or with the
Chapter 4 Troubleshooting Using the CLI
255
Table of Contents
