Table of Contents
Appendix A
Upgrading the GSS Software
6.
7.
8.
9.
10.
11.
12.
Note
13.
OL-10410-01
331 Password required for admin.
Password:
230 User admin logged in. Access restrictions apply.
Remote system type is UNIX.
Using ascii mode to transfer files.
ftp> binary
ftp> get
(remote-file) gss.upg
(local-file) gss.upg
local: gss.upg remote: gss.upg
200 PORT command successful.
...
Enable privileged EXEC mode.
gssm1.example.com> enable
gssm1.example.com#
Stop the GSS software by entering the following command:
gssm1.example.com# gss stop
If the GSS has CNR loaded on it, enter the Global Configuration Mode by
entering the enable command and then the config command.
If the GSS does not have CNR loaded on it, skip ahead to Step 11.
Disable CNR if the GSS has CNR loaded on it.
gssm1.example.com (config)# no cnr enable
Type exit to leave Global Configuration mode.
Install the upgrade by entering the following command:
gssm1.example.com# install gss.upg
At the Proceed with install (the device will reboot)? (y/n): prompt, type y to
reboot the GSS device. After the GSS reboots, you lose any network CLI
connections. Console connections remain active.
If you did not previously save changes to the startup-config file, the Save
current configuration? [y/n]: prompt appears. At the prompt, type y to
continue. The GSS then reboots.
After the GSS device reboots, log in to the GSS device and enable privileged
EXEC mode.
Cisco Global Site Selector Administration Guide
Upgrading Your GSS Devices
A-7
Hide quick links:
Table of Contents
