Rip User Configuration; Ip Information; Igmp Multicast Group Information - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual
Hp gbe2c ethernet blade switch for c-class bladesystem iscli reference guide
Hide thumbs
Also See for GbE2c - Blc Layer 2/3 Fiber SFP Option:
- Interface manual (209 pages) ,
- Command reference manual (175 pages) ,
- Application manual (165 pages)
Table of Contents
RIP user configuration
NOTE:
RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following command displays RIP user information:
show interface ip [<1-256>] rip
Command mode: All
RIP USER CONFIGURATION :
RIP on updat 30
RIP Interface 2 : 102.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1
auth none,key none
RIP Interface 3 : 103.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1
IP information
NOTE:
Layer 3 commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following command displays Layer 3 information:
show layer3 information
Command mode: All
Interface information:
1: 47.80.23.243
Default gateway information: metric strict
1: 47.80.22.1,
2: 47.80.225.2,
The following interface and default gateway information is displayed:
Interface number
IP address
IP mask
IP broadcast address
Operational status
IGMP multicast group information
The following table describes the commands used to display information about IGMP groups learned by the switch.
Table 35
IGMP Multicast Group commands
Command
show ip igmp groups
address
show ip igmp groups
vlan <1-4095>
show ip igmp groups
interface
show ip igmp groups
trunk <1-12>
show ip igmp groups
255.255.254.0
47.80.23.255,
up
up
Usage
Displays a single IGMP multicast group by its IP address.
Command mode: All except User EXEC
Displays all IGMP multicast groups on a single VLAN.
Command mode: All except User EXEC
Displays all IGMP multicast groups on a single port.
Command mode: All except User EXEC
Displays all IGMP multicast groups on a single trunk group.
Command mode: All except User EXEC
Displays information for all multicast groups.
Command mode: All except User EXEC
vlan 1, up
Information Commands 45
Table of Contents
