Powering On The Server; Factory Image; Physical Configuration; Aio Configurations - HP AK373A - StorageWorks All-in-One Storage System 1200r 5.4TB SAS Model NAS Server User Manual
Hp storageworks all-in-one storage system user guide (440583-006, june 2008)
Hide thumbs
Also See for AK373A - StorageWorks All-in-One Storage System 1200r 5.4TB SAS Model NAS Server:
- Release notes (21 pages) ,
- Release notes (10 pages) ,
- Release notes (19 pages)
Table of Contents
NOTE:
Depending on your system, the following components might also be included:
•
Bezel, bezel brackets, and screws
•
Slide rail assembly
•
Tower-to-rack conversion kit
•
HP ProLiant Essentials Integrated Lights-Out 2 Advanced Pack
•
HP ProLiant Essentials Lights-Out 100i Advanced Pack
Powering on the server
Power on the server after connecting the cables. For more information on your storage system model's
hardware components, see
1.
Power on the server by pushing the power button. The power LED illuminates green.
2.
When the server powers on, an installation progress screen is displayed. The installation process
takes approximately 10 to 15 minutes to complete and the server will reboot twice. No user
interaction is required.
CAUTION:
Do not interrupt the installation process; when the installation sequence is complete, the
system prompt appears.
3.
See
"Accessing the All-in-One Management
Factory image
The HP All-in-One Storage System is preconfigured with default storage settings and preinstalled with
the Windows Storage Server 2003 R2 operating system (OS). This section provides additional details
about the preconfigured storage.
Physical configuration
The DON'T ERASE logical disk supports the recovery process only and does not host a secondary
operating system. If the operating system has a failure that might result from corrupt system files, a
corrupt registry, or the system hangs during boot, see
Data volumes are not carved at the factory or by the System Recovery DVD, and must be configured
manually by the end user. Be sure to back up your user data, and then use the System Recovery DVD
to restore the server to the factory default state as soon as conveniently possible.
Table 4 AiO Configurations
•
AiO400r
•
AiO400t
22
Installing and configuring the server
"Server
components" on page 35.
Logical Disk 1
•
Operating System Volume
•
RAID 5
•
Physical Drives 1–4
Console" on page 23 to set up server access.
"System
recovery" on page 133.
Logical Disk 2
•
DON'T ERASE Volume
•
RAID 5
•
Physical Drives 1–4
Table of Contents
Troubleshooting
