Table of Contents
Chapter 5
Upgrading the 5-GHz Radio Module
Step 3
Remove the 5-GHz access cover using the supplied Torx L-wrench (see
Figure 5-1
1
Removing a 5-GHz Radio Module
To remove the 5-GHz radio module, follow these steps:
Remove all cables and power connections from the access point.
Step 1
Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 2
Unscrew the two mounting screws using the supplied Torx L-wrench
Step 3
Figure 5-2
1
2
Note
OL-8370-04
5-GHz Radio Access Cover
1
2
1
Access Cover Screws
5-GHz Radio Module
1
1
2
Mounting screws
5-GHz radio module antenna
Do not attempt to remove the mounting screws from the module; they are captured in the module
housing.
2
Access Cover
3
3
Access point
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Removing a 5-GHz Radio Module
Figure
5-1).
(Figure
5-2).
5-3
- Quick Links:
- Basic Installation Guidelines
Hide quick links:
Table of Contents
