Table of Contents
Chapter 18 IGMP
The following table describes the labels in this screen.
Table 38 Advanced Application > IGMP > Bandwidth Setup > Port Setup
LABEL
Bandwidth Setup
Port
Active
Bandwidth
Select
Active
Inactive
Select All
Select None
18.5 IGMP Setup Screen
Use this screen to configure your IGMP settings.
To open this screen, click Advanced Application > IGMP > IGMP Setup.
Figure 70 Advanced Application > IGMP > IGMP Setup
The following table describes the labels in this screen.
Table 39 Advanced Application > IGMP > IGMP Setup
LABEL
IGMP Status
Filter Setup
152
DESCRIPTION
Click Bandwidth Setup to open the IGMP Bandwidth screen where you can
set up bandwidth requirements for multicast channels (see
page
150).
This field shows each DSL port number.
This field shows whether or not multicast bandwidth requirements are enabled
on this port. "V" displays if it is enabled and "-" displays if it is disabled.
Enter the maximum acceptable multicast bandwidth for this port. This has no
effect if bandwidth requirements are disabled.
Select this, and click Active or Inactive to enable or disable the specified
multicast bandwidth requirements on this port.
Click this to enable the specified multicast bandwidth requirements on the
selected port.
Click this to disable the specified multicast bandwidth requirements on the
selected port.
Click this to select all entries in the table.
Click this to un-select all entries in the table.
DESCRIPTION
Click IGMP Status to open the IGMP Setup screen where you can view current
IGMP information (see
Section 18.3 on page
(STU-C mode only) Click Filter Setup to open the IGMP Filter Profile screen
where you can configure IGMP multicast filter profiles (see
page
153).
Section 18.4 on
148).
Section 18.6 on
IES-708-22A User's Guide
Table of Contents
Troubleshooting
