Table of Contents
SM Series Heat Pump
Blower configuration changes should be done prior
to unit being installed in the final location.
Required Tools
•
5/16" hex head driver
•
3/8" hex head driver
•
7/16" hex head driver
•
Flathead screw driver
•
Phillips screw driver
•
1/4" hex head driver
•
Needle nose pliers
•
5/16"-1/4" ratchet wrench
Instructions - Left-Hand Unit (SM0**-
1HZ-*L*-**)
1.
Remove and retain end and side panels.(Figure #6)
Figure # 6
2.
Disconnect blower motor wiring and ground wire
fastened to blower housing.(Figure#7)
Figure # 7
Revised 07-17
3.
Remove and retain bracket by removing (3) screws.
(Figure #8)
Figure # 8
4.
Loosen blower assembly by removing (4) screws.
(Figure #9)
Figure # 9
5.
Remove and retain bracket by removing (2) screws.
(Figure #10)
Figure # 10
Horizontal Configurability | 7
8733942411 (2017/06)
Table of Contents
