Page 1
No. 0534 CML200UXWB SERVICE MANUAL MANUEL D'ENTRETIEN WARTUNGSHANDBUCH CAUTION: Before servicing this chassis, it is important that the service technician read the “Safety Precautions” and “Product Safety Notices” in this service manual. Data contained within this Service manual is subject to alteration for improvement.
1. Precautions and Notices 1.1 Safety Precautions Although LCD monitors are displays without high voltage as that in the CRTs, the following precautions still should be take care of. 1) Observe all cautions and safety related notes located inside the display cabinet and on the display chassis.
3. Adjusting Your Display This chapter contains information about how to changing display settings for your LCD Monitor. It is designed with an OSD menu to help you easily adjust to its optimum performance. Note: You must perform auto setup before making any adjustment. Summary of Control Buttons There are three control buttons located at the lower part of the front panel of your display: Select: Display the On-Screen Display (OSD) “Main Menu”...
4. Disassembly Instructions To disassembly the monitor, follow the steps as below: 1) Face Down the Monitor. Note: Face the monitor down on a smooth plane with a soft material on that plane to protect the panel faceplate. 2) Hinge Cover and base Removal As below, remove the hinge cover and the 4 screw “B”...
Page 9
3) Back Cover Removal: As below, after removing the base, there will be 7 screws (indicated by “D”), and remove them. Then you can remove the back covere “E” of the monitor. 4) Metallic Cover Removal: Remove 12 screws indicated as “F” from the back metallic cover. Then remove the back metallic cover “G”.
Page 10
5) PCB Assembly Removal: Caution: When serving or replacing the panel, disconnect the DC power jack completely. (a) Unplug all connected wires from the PCB. (b) Remove 4 screws indicated as “H” from the audio board, and then remove the board carefully.
Page 11
6) Speaker Removal: As below, remove the 6 screw “A” then remove the back cover “D”. Remove the 4 screen “B” to remove the trumpet and 2 screen “C” to remove the speaker audio in connector.
5. General Connection and Applications Procedures for installing and using this CML171SX LCD monitor are described as below. 5.1 Connecting the monitor to the computer 1) Place the display on a flat, sturdy surface. Choose an area free from excessive heat, moisture, and sunlight.
Pin Assignment of 15-pin D-SUB connector Red Video +5V for DDC circuit Green Video Logic Ground Blue Video Monitor Ground Monitor Ground DDC-Serial Data DDC-Return H-Sync. Red Ground V-Sync. Green Ground DDC-Serial Clock Blue Ground Pin Assignment of 25-pin DVI-D connector RX2- RX2+ DETECT...
8. Troubleshooting Flow Chart No image appear Voltage of P310(PWB-0433) at pin Replace PWB-0433 LED light up 3,4 are 5V and pin 7,8 are 12V LED display is LED Display is amber green Replace MCU I005 Voltage of P010(PWB-0432) at pin Replace PWB-0433 28,29,30 are 12V Is LVDS cable...
Page 16
No sound output (PWB-0433) Are the waveforms at pin 15(L_IN) and Check audio source pin 2(R_IN) of I301 normal Are the waveforms at pin 1(L_OUT) and Replace PWB-0433 pin 7(R_OUT) of P306 normal Are two speakers Replace speakers working correctly...