Table of Contents
4.5 Binding procedure for room thermostat and ATW-IOT-01
By default, when both the ATW-IOT-01 receiver and ATW-RTU-12 devices are acquired as the ATW-
RTU-11 bundle, they arrive pre-linked right out of the package.
Consequently, if only one wireless thermostat is required for the installation, there is no need to go
through the binding procedure.
To configure the "Wireless Thermostat" option for the desired circuit, make sure to use the Unit
LCD. For instructions on setting up the Wireless thermostat on the YUTAKI LCD, refer to the unit
controller documentation.
The binding operation described below is required if:
• Any of the system components (ATW-RTU-12 or ATW-IOT-01) are replaced.
• ATW-IOT-01 has incorrect or no binding data stored (e.g. when pre-bound system pack
components have been mismatched).
• When adding a second wireless thermostat.
4.5.1 Binding description
There are two methods for binding ATW-IOT-01 and ATW-RTU-12:
1 Through the CSNET Home application.
4
2 Using the push buttons.
We recommend utilizing the CSNET Home application for the binding procedure because it
provides a user-friendly, self-explanatory workflow.
If, for any reason, you cannot use the application, the push button method is an alternative option.
It's important to note that the binding operation through the CSNET Home application can be
performed even when there is no internet connection. An internet connection is only necessary for
downloading the application.
30
PMEN0651 rev.0 - 10/2023
Table of Contents
