Black & Decker HSVB420J, HSVB520J - Powerseries 2-in-1 Cordless Stick Vacuum Cleaner & Hand Vac Manual

DEFINITIONS: SAFETY ALERT SYMBOLS AND WORDS

This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage.

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
(Used without word) Indicates a safety related message.
NOTICE: Indicates a practice not related to personal injury which, if not avoided, may result in property damage.

SYMBOLS

The label on your tool may include the following symbols. The symbols and their definitions are as follows:

V		volts
A		amperes
Hz		hertz
W		watts
min		minutes
or AC		alternating current
or DC		direct current
		no load speed
		Class I Construction (grounded)
		earthing terminal
		safety alert symbol
		Class II Construction (double insulated)
.../min or rpm.		revolutions or reciprocation per minute
Wh		Watt Hours

ASSEMBLY

Do not attempt to modify or repair the appliance.

Intended use

Your BLACK+DECKER lithium ion cordless 2 in 1 stick vacuum cleaner has been designed for light, dry vacuum cleaning purposes. This appliance is intended for household use only.

Assembly

1. Raise the handle until it locks in place and twist the handle lock to the locked position as shown in Fig. B
2. Insert the hand vacuum into the stick vacuum chassis as shown in Fig. C, ensuring it clicks firmly into place.
3. Align the bottom of the stick vacuum chassis with the floor head .
4. Push the bottom of the stick vacuum chassis onto the floor head so it locks into position as shown in Fig. C.
5. Pull the accessory from the stick vacuum chassis .
6. To store an accessory, press the accessory into the stick vacuum chassis .

When not in use position the unit with the rear of the vacuum facing a wall so that any inadvertent fall of the unit would contact a wall and not people or pets.

Charging the battery

For use only with the supplied charger.
From new, the rechargeable cells of the product need a minimum charge time of 5 hours to ensure full power.

1. Ensure the hand vacuum is docked securely into the stick vacuum chassis.
   
2. Plug the jack plug of the charger into the charging port located on the stick vacuum chassis.
3. The LED flashes RED during normal charge and turns GREEN for 60 seconds when the battery is fully charged.
4. Fast RED blink indicates a bad battery pack. Please contact your BLACK+DECKER dealer.
   Visit www.blackanddecker.com to locate dealers.

Battery discharging

1. The LED is GREEN when discharging.
2. Once the unit is fully discharged, the LED will flash RED for 10 seconds every time the handvac or stick vac ON/OFF switch is pressed and the unit will not turn ON.
3. A charge cycle is required before the unit will turn ON.

Do not charge the battery at ambient temperatures below 39°F (4°C) or above 104°F (40°C). Follow all charging instructions and do not charge the appliance outside of the temperature range specified in the instructions.

Removing / Installing Hand Vac

To remove hand vac:

1. Press the hand vacuum release button .
2. Lift the hand vacuum from the stick vacuum chassis .

To install hand vac:

3. Insert the hand vacuum into the stick vacuum chassis as shown in Fig. C, ensuring it clicks firmly into place.

Switching ON and OFF

Hand Vac Mode

1. To switch ON, press the ON/OFF power button .
2. To switch OFF, press the ON/OFF power button .
   NOTE: Return the product to the charger immediately after use so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged with the charger plug.

Stick Vac Mode

1. To switch ON, press the Stick vacuum ON/OFF button .
2. For increased power, press the power boost button .
   NOTE: Pressing the power boost button more than once will cycle the power of the rotary brushes from normal to boosted.
3. To switch OFF, press the Stick vacuum ON/OFF button .
   NOTE: Return the product to the charger immediately after use so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged with the charger plug.

Hand Vac Accessories

Your hand vacuum may be supplied with some of the following accessory:

• The brush tool is designed for more effective cleaning of upholstered furniture and fabric.
• The crevice tool allows for vacuuming in narrow and hard to-reach places.

Fitting

1. Insert the appropriate accessory into the front of the hand vacuum as show in Figure E.

Dry pick up

For everyday spills of dry material.

• Do not fill the dust bowl beyond the end of the intake chute.

Optimizing the suction force

In order to keep the suction force optimized, the filters must be cleaned regularly during use.

Emptying and Cleaning

Removing the dust bowl and filter

The filter is reusable and should be cleaned regularly.

1. Press the dust bowl release button and pull the dust bowl straight off as shown in Fig. F.
2. While holding the dust bowl over a trash can, pull out the filter assembly to empty the contents.
3. Rotate filter counterclockwise to unlock and remove it from the pre filter . Gently remove any debris.

Never use the appliance without the filters. Optimum dust collection will only be achieved with a clean filter.

Cleaning the dust bowl and filter

The dust bowl , pre filter and filter can be washed in warm soapy water.

1. Make sure the pre filter , filter and the dust bowl are completely dry before installing.

Removing and cleaning the rotary brushes

To reduce the risk of injury from moving parts, disconnect the floor head from the vacuum before cleaning or servicing.

• To remove the rotary brush , pinch and lift the plastic tab on the pivoting clip away from the floor head .
• Lift the rotary brush out of the floor head. Clear the brushes of any hair or other debris that may have accumulated.

Replacing the filters

The filters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement filters are available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.

• Remove the old filters as described in Cleaning the Filters.
• Fit the new filters as described in Cleaning the Filters.
  (cat. no: SVF12)

MAINTENANCE

Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the vac; never immerse any part of the vacuum into a liquid.

Make sure the vacuum is completely dry before using it.

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.

TROUBLESHOOTING

If the product does not work, check the following:

If vacuum performance is poor, check the following:

For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK+DECKER help line at 1–800–544–6986.

ACCESSORIES

Recommended accessories for use with your appliance are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986.

The use of any accessory not recommended for use with this appliance could be hazardous.

SERVICE INFORMATION

All BLACK+DECKER Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the BLACK+DECKER location nearest you. To find your local service location, call: 1-800-544-6986 or visit www.blackanddecker.com

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliances, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury.

Some household dust contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm such as asbestos and lead in lead based paint.

Do not attempt to modify or repair the appliance.

Do not charge the battery at ambient temperatures below 39°F (4°C) or above 104°F (40°C). Follow all charging instructions and do not charge the appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase risk of fire.

To reduce the risk of fire, electrical shock or injury:

• Shock Hazard. To protect against risk of electrical shock, do not put charging base in water or other liquid.

ADDITIONAL SAFETY WARNINGS

1. Prevent unintentional starting. Ensure the switch is in the off-position before picking up or carrying the appliance. Carrying the appliance with your finger on the switch or energizing appliance that have the switch on invites accidents.
2. Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
3. Do not use a battery pack or appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
4. Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 266°F (130°C) may cause explosion.
5. Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.
6. Only for use with HSVB420: JOD-S-180050A1 / BLJ15L180050P-U, HSVB520: JOD-S-220050A1 / BLJ15L220050P-U chargers.

BlackandDecker.com
1-800-544-6986
Imported by Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286