Table of Contents
FLEXIDOME micro 3100i
5.7.4
Network Management
SNMP
The camera supports two versions of Simple Network Management Protocol (SNMP) for
managing and monitoring network components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code.
Select either of the options that follow for the SNMP parameter:
–
–
If you select either of the SNMP version, but do not enter an SNMP host address, the
camera does not send messages (traps) automatically, but only replies to SNMP requests.
Select Off to deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
SNMP v1 legacy
When you select SNMP v1 legacy in the field SNMP, the fields Write community and SNMP
traps appear.
Write community
Type the password for Write community to allow the exchange of data between connected
devices.
SNMP traps
You can select which traps are to be sent.
1.
2.
3.
SNMP v3
When you select SNMP v3 in the field SNMP, the tabs User and Trap user show.
The same fields show in both tabs.
The SNMP engine ID field also appears, indicating the unique identifier of the SNMP entity.
User name
Enter the appropriate user name.
Authentication protocol
Select the appropriate authentication protocol: None, MD5, or SHA1.
Authentication password
Enter the appropriate password for authentication.
Privacy protocol
Select the appropriate privacy protocol: None, DES, or AES.
Privacy password
Enter the appropriate password.
Read-only
To make this information read-only, select this check box.
Quality of service
The camera offers Quality of Service (QoS) configuration options to ensure fast network
response to PTZ data and images. Quality of Service (QoS) is the set of techniques to
manage network resources. QoS manages the delay, delay variation (jitter), bandwidth, and
packet loss parameters to guarantee the ability of a network to deliver predictable results.
QoS identifies the type of data in a data packet and divides the packets into traffic classes
that can be prioritized for forwarding.
Bosch Security Systems B.V.
SNMP v1 legacy
SNMP v3
Click Select. A list is opened.
Click the checkboxes to select the required traps. All the checked traps will be sent.
Click Set to accept the selection.
User manual
Configuration | en
2023-11 | V01 | F.01U.408.367
47
Table of Contents
