Table of Contents
ANL & NOISE
TONE
BLANKER
SWITCH
SWITCH
CB/PA
ANTENNA
SWITCH WARNING LED CHANNEL
INDICATOR READOUT
LIGHT
TX TRANSMIT
INDICATOR LIGHT
RF/S METER
MICROPHONE
JACK
(ON CABINET SIDE)
CHANNEL
SWITCH
GENERAL EtteiRIC
VOLUME
ON-OFF SQUELCH RF GAIN + CLARIFIER CONTROLS
MODE
POWER CONTROL MIC POWER (COAR SE & FINE TUNE) SWITCH
SWITCH
CONTROL
RF/S METE
The METER on this transceiver serves two functions:
1. When Receiving, it indicates the relative incoming signal strength (RX signal) in "S" units
on the upper half scale.
2. In the Transmit mode, it indicates the relative "RF" (Transmit-TX) power output from your
Transceiver on the lower half scale.
EXTERNAL SPEAKER JACK
An optional remote 8 ohm speaker may be used (for mobile installation) to overcome muffled
sound caused by carpet or other obstructions. With remote speaker plugged into 3.5 mm
EXT. SP. jack, the internal speaker is automatically disconnected.
PUBLIC ADDRESS (PA) FEATURES
Use as a PA amplifier with optional 8 ohm PA speaker as follows:
1. Connect 3.5 mm plug from PA Speaker to the PA jack located on the cabinet back.
2. Turn unit to ON position by rotating VOLUME ON-OFF switch.
NOTE:
While in PA or PA/CB mode, all audio output is directed to the PA jack and the
internal speaker is disconnected.
CR/PA SWITCH POSITI(
•
PA — For PA operation only, press in the MICROPHONE pushbutton and talk in a normal
voice.
PA loudness can only be varied by the MIC POWER knob. Channel LED will be OFF in
PA mode.
•
PA/CB — When not using PA, and MIC switch is released, you can listen to (monitor) CB
transmission through the PA speaker. Volume is adjustable for CB monitor and PA loudness
only by the MIC POWER control.
•
CB — Returns unit to normal mode of operation.
IMPORTANT:
Mount PA speaker facing away from MIC and as far as possible from unit to
prevent high-pitched sounds (feedback howl) at maximum MIC POWER loudness.
12
Table of Contents
