Device Code Setup; Searching And Sampling The Code Of A Device (991) - Toshiba COLOASTREAM 43AX60 Owner's Manual
Hide thumbs
Also See for COLOASTREAM 43AX60:
- Owner's manual (54 pages) ,
- Service manual (8 pages) ,
- Service manual (104 pages)
Table of Contents
Programming
the remote control for use with
your audio/video
devices
Device code setup
1. Refer to the Device code table on pages 16-19 to find the number
that corresponds to the brand name of your device.
If more than one number is listed, try each one separately until
you
find
tbe
one
that works.
2. Press MODE until tbe Mode indicator of the device (CABLE/
SAT, VCR, DVD, AUDIO 1, AUDIO2)
lights up.
3. Hold down the RECALL button wbile using the Number
buttons to enter tile four digit code number of your brand of
device.
If a valid code has been entered, the *node indicator will blink
twice. If an invalid code is entered, there will be one long blink.
4. Point tile remote control at the device and press POWER to test
the code number.
If the device turns on, ?_u have entered the right number.
If the device does not respond to the remote control, you may
have entered the wrong number. Repeat steps 3 and 4 using
another code number.
5. Press MODE to select theTV mode to control the TV.
Searching
and sampling
the code of a device ([991}
If you do not know the de_'ice code for a particular target unit, }_u
can cycle the remote through the available codes _or that de_'ice mode
and sample functions in order to find the code that properly operates
the desired target device. Tbe keys available to be sampled, provided
they are applicable to tbat mode, are 0, 1,2, 3, POWER, VOL A,
CH A, PLAY and STOE Invalid keys will be ignored wbile in
program mode.
To cycle through each available device code and sample its fimctions:
1. Press MODE to select the mode you want to set up.
2. While holding down the RECALL button, press 9, 9, 1 in
sequence. The remote control will enter program mode.
3. Point the remote at *be target device, then press POWER (or
other flmction buttons that are available to be sampled).
4. If*be device responds to the remote:
Press RECALL to store the device code.
The mode indicator will blink twice and the remote will exit
the program mode.
If the device does not respond to the remote:
Press Mere= • then press POWER.
Repeat this step until the device responds to the remote, tben
press RECALL.
Note: ff a seard} cycle has been completed, *be mode indicator wi// b/ink three
times Theremote wi// begin to cycle through the availablecodes again
ff no key is pressed witbin ten seconds wbi/eprogramming, the remote
will exit*he program mode and return to the previous code
POWER
Number
MODE
Menu •
RECALL
Note:
• Ead_time you rep/ace *be batteries,you
must t_ptogt_m the I_mote contro_
• Some newer VCRsaf_ capable of working
on either of two remote codes TheseVCRs
/}avea switcb labeled "VCRZ /VCR2 _
ffyouf VCR bas this kind of switch,it may
not i_spond to any of *be code numbers for
your VCRbrand name le tbis case, set the
switch to the other position (VCR[ or
VCR2) and fepfogf_m the/_mote controZ
14
Table of Contents
