Table of Contents
Available languages
Available languages
Vacuuming
Dry Materials
1. The filter must always be in correct
position to reduce the risk of leaks and
possible damage to Vac.
2. When using your Vac to pick up very
fine dust, it will be necessary for you to
empty the drum and clean the filter at
more frequent intervals to maintain
peak Vac performance.
NOTE: A dry filter is necessary to pick up
dry material. If you use your Vac to pick
up dust when the filter is wet, the filter will
clog quickly and be very difficult to clean.
The optional Craftsman HEPA Rated
Material Filter, stock number 9-17912 will
do a better job stopping very fine parti-
cles than the 9-17816 filter.
Vacuuming
Liquids
_, WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
Emptying
the Drum
1. Remove the power assembly. Push
down and pull out the flexible locking
tabs to release from drum.
2. While holding the locking tabs out, lift
the power assembly up and away from
the drum.
3. Lay power assembly upside down on a
clean area while emptying drum.
4. Dump the drum contents into the prop-
er waste disposal container.
5. The 113.179675, 9-Gallon Wet/Dry Vac
comes equipped with a drain for easy
emptying of liquids. Simply unscrew the
drain cap and lift the opposite side
slightly to empty the drum.
_, WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
1. When picking up small amounts of liq-
uid the filter may be left in place.
2. When picking up large amounts of liq-
uid we recommend that the filter be
removed. If the filter is not removed, it
will become saturated and misting may
appear in the exhaust.
3. After using the Vac to pick up liquids,
the filter must be dried to reduce the
risk of possible mildew and damage to
the filter.
4. When the liquid in the drum reaches a
predetermined
level, the float mecha-
nism will rise automatically to cut off
air-flow. When this happens, turn off
the Vac, unplug the power cord, and
empty the drum. You will know that the
float has risen because Vac airflow
ceases and the motor noise will
become higher in pitch, due to
increased motor speed.
IMPORTANT: To reduce the risk of dam-
age to the Vac do not run motor with float
in raised position.
Blowing
Feature
Your Vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a blower.
1. Locate blowing port of your Vac.
Hide quick links:
Chapters
Table of Contents
