Samsung RF25HMEDBSR - Refrigerator Installation Guide

Samsung RF25HMEDBSR - Refrigerator Installation Guide

Also See for RF25HMEDBSR:
Samsung RF25HMEDBSR - Refrigerator Installation Guide

Leveling & Door Alignment

  • For details, refer to "Leveling the Refrigerator" in the User Manual.
  • Insert a flat-blade screwdriver into a slot on the control lever, turn it clockwise or counterclockwise to level the refrigerator.
    Leveling & Door Alignment


When the refrigerator is empty, adjust CAUTION the Leveling Leg Control by turning it clockwise or counterclockwise with a flat head screwdriver until the Leveling tact to the floor.
This will allow better balance of the Refrigerator when it is empty.

Door Alignment

Type A

  • Open the freezer drawer to gain access to the adjustable hinge pin. Next, adjust the refrigerator door using the provided 0.16 inch allen wrench.
  • Insert the provided snap rings.
    (on some models)
    Door Alignment - Type A


Keep the snap rings out of reach of children.

Type B (RF32FMQ**, RF34**)

  • Adjust the door height difference by inserting a Snap Ring (1) as shown between the door and the hinge.
    Insert one snap ring only of the correct thickness.
    Door Alignment - Type B


Keep the snap rings out of reach of children.

Automatic Ice Maker does not work

  • Allow your refrigerator to operate and cool down for 24 hours (1 full day) before dispensing large quantities of ice.
  • To fill the ice bucket to maximum capacity, dispense a few cubes 8 and 16 hours after installation.
  • If ICE OFF or Ice Maker Off is lit, the ice maker will not make ice.
  • To activate the ice maker, press ICE OFF or the Ice Maker Off button on the control panel so it is no longer lit.

Slow Ice Production

  • Check if the ice bucket is completely inserted.
  • Freezer temp may not be low enough.
    Set it to -2°F (-19°C) or lower.

Small ice cubes, ice cubes with bubbles, or slow water dispensing

  • If the water filter is clogged, the ice maker may produce small ice cubes or ice cubes with bubbles.
  • Replace the water filter cartridge with a new one.

Water filter replacement

After installation or when replacing the water filter, dispense at least 1 gallon (2~3 minutes) of water to remove trapped air from the water line. Otherwise, water may drip from the dispenser after you dispense water.

Water is not cool enough

  • The first glass of water may not be cold enough because the stored water in the water tank has not cooled completely.
    Dispense several glasses of water until the water is cool enough.

Water dispenser dripping

  • If the water line is not inserted into the coupler properly, air could penetrate into the water line causing water to drip from the water dispenser.

  • Insert the water line into the coupler completely and slide in the clip at the end of the coupler.
    Water dispenser dripping
  1. The Water Line must be fully inserted to the center of the transparent coupler (Type A) or the Guide Lines (Type B) to prevent water leakage from the dispenser.
    The Water Line
  2. Insert the Clip A from the install pack and confirm that it holds the line firmly.

Fridge or freezer Compartments are warm

  • Allow your refrigerator to operate and cool down for 24 hours (1 full day) to reach the temperature you set.
  • Also, when you put room temperature or warmer food into your refrigerator, it may need an additional 24 hours to reach the set temperature.

Moisture forms on outside/inside of refrigerator

  • Wipe off the condensation with a dry towel.
    (This may occur during hot and humid weather.)

Noise Clicks, Pops, Cracks, Snaps

Display

  • Filter indicator: The filter Indicator turns red after you use about 300 gallons of water (about 6 months of usage). Reset the indicator (it will be Blue or off) after replacing the filter by holding the filter reset button for 3 seconds.
  • Ice off: Press the "Ice Off" or "Ice Maker Off" button to turn the ice making function off.
  • Cooling Off (Show Room) mode: If the Display shows the "0F 0F" (or OFF) code, it means that the Cooling Off function is activated and the refrigerator is not cooling.
    To cancel the Cooling Off mode, press the multiple buttons on the display specified in the user's manual.

Food stored in refrigerator is frozen

  • If food with too much moisture is stored near the cooling vents, it may get frozen. Be sure to keep moist food away from the cooling vents.

Moving the Refrigerator

  • When moving the refrigerator, pull or push it straight forward or backward.
    Do not wiggle it from side to side.
    Moving the Refrigerator

Before installation & calling service
If you have further questions or your refrigerator has damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864).

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Need Assistance?

Do you have a question about the RF25HMEDBSR that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents