Table of Contents
efesotomasyon.com -Toshiba inverter,drive,servo,plc
3.2
Simplified Operation of the VF-nC3
The procedures for setting operation frequency and the methods of operation can be selected from the following.
Run / Stop
Setting the frequency
3
Use the basic parameters (command mode selection)
and (frequency setting mode selection) for selection.
Title
☆ fmod=2 (setting dial 2) is the mode where after the frequency is set by the setting dial, the frequency is
saved even if the power is turned off.
☆ See E6581595, 5.5 for details of = and .
: (1) Run and stop using the panel keypad
(2) Run and stop using external signals to terminal
board
: (1) Setting using setting dial
(2) Setting using external signals to terminal board
(0-5V/0-10Vdc, 4-20mAdc)
Function
Command mode selection
Frequency setting mode
selection
Adjustment range
0: Terminal board
1: Panel keypad (including remote
keypad)
2: RS485 communication
0: Terminal board VI
1: Setting dial 1 (press in center to
save)
2: Setting dial 2 (save even if power is
off)
3: RS485 communication
4: -
5: UP/DOWN form external logic input
C-4
E6581595
Default setting
1
2
Table of Contents
