Table of Contents
Available languages
Available languages
1.
Switch operation
Lock-off button
Switch trigger
Fig. 23
WARNING:
2.
Using the Vise Assembly (Standard accessory)
Screw holder
Hex. socket
set screw
Vise shaft
Fence
Fig. 24
WARNING:
CAUTION:
The tool will not start unless the Lock-off button is pressed
while the switch is pulled back.
The Lock-off button can be engaged by pressing it from the
left.
After the switch is on, the saw blade will continue to operate
as long as you pull on the switch trigger, even if you release
the Lock-off button.
When the switch is released, the Lock-off button
automatically disengages to prevent inadvertent motor
startup.
Never lock the Lock-off button in depressed position.
Pulling back the switch would then cause the tool to suddenly
start operating, which could result in injury.
To prevent unauthorized operation of this tool, insert a padlock
through the hole in the switch trigger.
Knob
(1) The vise assembly can be mounted on the base.
(2) Turn the upper knob and securely fi x the workpiece
Vise plate
Workpiece
Always fi rmly clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
Always confi rm that the motor head (see Fig. 1) does not contact
the vise assembly when it is lowered for cutting. If there is any
danger that it may do so, loosen the Hex. socket set screw and
move the vise assembly to a position where it will not contact the
saw blade.
in position (Fig. 24).
English
23
Table of Contents
