Table of Contents
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the solid-state drive (see
4.
Remove the battery (see
5.
Remove the fans (see
6.
Remove the heat sink (see
7.
Remove the system board (see
Remove the wireless antenna:
1.
Release the tape (1) that secures the wireless antenna cables to the computer.
2.
Release the wireless antenna cables from the retention clips (2) and channels that are built into the
computer.
3.
Detach the wireless antenna transceivers (3) from the computer. The wireless antenna transceivers
are attached to the computer with double-sided adhesive.
4.
Remove the wireless antenna.
To install the wireless antenna, reverse the removal procedure.
Fingerprint reader cable
To remove the fingerprint reader cable, use this procedure and illustration.
NOTE:
The fingerprint reader cable is included in the Cable Kit, spare part number N10935-001.
Before removing the fingerprint reader cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the solid-state drive (see
Preparation for disassembly on page
Bottom cover on page
Solid-state drive on page
Battery on page
46).
Fans on page
49).
Heat sink on page
System board on page
Preparation for disassembly on page
Bottom cover on page
Solid-state drive on page
40).
42).
49).
62).
40).
42).
40).
40).
Fingerprint reader cable
67
- Quick Links:
- Locating Hardware
- Solid-State Drive
Hide quick links:
Table of Contents
