Table of Contents
3.3
Network Settings
This section details how to check and setup the network settings.
3.3.1
Check IP Settings:
Check the IP setting by entering the following command into Terminal/Command Line:
$ nmcli con show
NETWORKPROFILE
refers to one of the system's network connections as follows:
For example, to pull up the IP settings for LAN1, us the following command:
$ nmcli con show
You should see the following results:
Chapter 3 – Gateway Setup and Configuration
NETWORKPROFILE
NETWORKPROFILE
Ethernet0
Ethernet1
Modem
Ethernet0
Port/Hardware
LAN1
LAN2
4G LTE module
15
Table of Contents
