Table of Contents
5 BOOTCODE AND FIRMWARE UPGRADE
IP address: 192.168.37.XXX
Netmask: 255.255.255.0 and
Gateway: 192.168.37.10 (if desired).
XXX is a number between 0 and 255 that is not assigned to any other device to avoid collisions.
If there are not TCP/IP settings according to this pattern in the computer, it should be added (in order to communicate with
the relay) following these steps:
Go to the Control Panel of the computer and select the Network option (the name of this option may depend on the PC
boot code).
In Network, enter in Protocols, select TCP/IP protocol and click on Properties.
In the IP address tab, select Advanced... (see Figure 5–3:) and add a new address in the PC that corresponds to the
same LAN pattern that the relay has (in the example bellow 192.168.37.54).
GEK-113328A
Figure 5–2: NETWORK IN CONTROL PANEL
Figure 5–3: TCP/IP PROPERTIES
G650 Generator Protection & Control System
5.1 INTRODUCTION
5
5-3
Table of Contents
