Processor - HP EliteDesk 800 G4 SFF Maintenance And Service Manual
Business pc
Hide thumbs
Also See for EliteDesk 800 G4 SFF:
- Disassembly instructions manual (10 pages) ,
- Maintenance and service manual (147 pages)
Table of Contents
Processor
For a list of available processors, see
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the air duct
4.
Remove the fan sink
5.
Pull the locking lever away from the processor socket (1).
6.
Rotate the locking lever to its full open position (2).
7.
Raise and rotate the microprocessor retainer to its fully open position (3).
8.
Lift the processor (4) straight up and remove it.
CAUTION:
them could cause irreparable damage. Once pins are damaged it may be necessary to replace the
system board.
The heat sink must be installed within 24 hours of installing the processor to prevent damage to the
processor's solder connections.
NOTE:
After installing a new processor onto the system board, always update the system ROM to ensure
that the latest version of the BIOS is being used on the computer. The latest system BIOS can be found on the
Web at: http://www.hp.com/support.
58
Chapter 4 Removal and replacement procedures
Computer major components on page
(Access panel on page
(Air duct on page
(Fan sink on page
Do NOT handle the pins in the processor socket. These pins are very fragile and handling
(Preparation for disassembly on page
18).
51).
54).
4.
17).
Hide quick links:
Table of Contents
