Black & Decker Quickpress AS70, AS75, AS80, AS85 Series Manual
Overview
- Spray nozzle
- Water-fill opening
- Dry/variable steam selector
- Spray button
- Surge-of-steam button
- Power on and temperature-ready light
- Heel rest with fabric guide
- Fabric-select dial
- Water tank
- Soleplate
Symbols
Dry
Steam/Blast of Steam
Spray
How to Use
This appliance is for household use only.
GETTING STARTED
Remove any labels, stickers or tags attached to the body or soleplate of the iron.
For warranty verification, do not remove line cord sticker.
Note: Use ordinary tap water for ironing. Do not use water processed through a home softening system.
For optimum performance, let the iron stand until the indicator light goes out (approximately 60 to 90 seconds) before beginning to iron.
TO FILL WATER TANK
Tip: If unsure of a garment's fiber, test a small area (on an inside seam or hem) before ironing.
FOR STEAM IRONING
- Move the selector to the desired steam level (A).
- Turn the fabric-select dial to appropriate setting (between 4 and 6) for your fabric (B). See fabric guide on the heel rest and read garment's label to help you determine fabric type. The temperature ready light glows until it reaches the appropriate temperature. It then cycles on and off during ironing.
FOR DRY IRONING
SURGE OF STEAM
- Horizontal
- To remove tough wrinkles, pump the button a few times at 5-second intervals for a concentrated blast of steam.
- Vertical
- Pull the fabric tight in your free hand and pump the button as you move the iron over the fabric (C).
SPRAY
You can use spray at any setting. Check that the water tank is filled with water. Press the button. If spray is weak, pump the button a few times.
EMPTYING WATER TANK AFTER IRONING
- Empty the water by holding the iron over a sink with the tip pointing down. Water will empty out of water-fill opening (D).
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service personnel.
CLEANING OUTSIDE SURFACES
STORING YOUR IRON
- Unplug the iron and allow it to cool.
- Check that the selector is set to min.
- Wrap the cord loosely around the heel rest and tuck in the plug to secure it.
- Store vertically on its heel rest to prevent water leaking from the soleplate.
IMPORTANT SAFETY INSTRUCTIONS
When using your iron, basic safety precautions should always be followed, including the following:
SPECIAL INSTRUCTIONS
USA/Canada 1-800-231-9786
Mexico 01-800-714-2503
www.blackanddecker.com
Accessories/Parts (USA/Canada) 1-800-738-0245
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.