Summary of Contents for Honeywell Ex-Or LightSpot Silver Series
Page 1
Honeywell Silver Series LightSpot with photocell MS1221PF / MS1221PSM MS1221PF MS1221PSM Installation and Commissioning Instructions Note: Infrared Programmer QuickSet Pro required for commissioning Honeywell Ex-Or Albery House, Springfield Road, At the end of their useful life Horsham, West Sussex RH12 2PQ...
Page 2
Silver Series LightSpot with photocell The Silver Series LightSpot is a high performance presence detector with photocell. In all operating modes, the photocell can hold lights off as a vacant area becomes occupied, and if the light level falls too low during the period of occupancy, the lights switch on.
Page 3
Parameter Options R1 and R2 Off Delay Independent Off Delays of between 1 minute and 96 hours may be set for each Relay. A 10-second Off Delay is available for walk-testing the product. In a typical office environment a 20-minute Off Delay is usually satisfactory. Response (Automatic / Semi-Automatic) Where absence detection is required (i.e.
Page 4
Setting the Photocell (Photocell only affects the ‘Live Out’ output) If the lights are not already on, switch them on manually by pressing ‘Utilities / LightSpot/MLS/LCM / IR Remote / Luminaire+ / OK’ on the QuickSet Pro. Fluorescent lights do not reach full output until up to 15 minutes after being switched on, so ensure that the lights are fully warmed up before continuing.