Solid-State Drive; Removing The 2230 Solid-State Drive - Dell XPS 8960 Service Manual

NOTE:

To achieve dual-channel support when installing two memory modules of the same capacity, install the memory

modules in DIMM 1 and 2 or DIMM 3 and 4.

4. Place the computer in an upright position.

Next steps

1. Install the

left-side

cover.

2. Follow the procedure in

Prerequisites

1. Follow the procedure in

2. Remove the

left-side

About this task

NOTE:

Depending on the configuration ordered, your computer may have up to two M.2 2230/2280 solid-state drives

installed in the two M.2 solid-state drive slots on the system board.

The following image(s) indicate the location of the 2230 solid-state drive and provides a visual representation of the removal

procedure.

Steps

1. Place the computer on its side with the left side facing up.

2. Remove the screw (M2x3) that secures the 2230 solid-state drive to the system board.

3. Slide and lift the 2230 solid-state drive from the M.2 card slot on the system board.

28

Removing and installing components

After working inside your

Before working inside your

cover.

computer.

computer.