Table of Contents
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 12
Note: If the appliance has been
previously switched off using the
control panel, press and hold
for ten seconds.
a The appliance begins to cool.
a A warning tone sounds, the tem-
perature display (freezer compart-
ment) flashes,
and the status display lights up red
because the freezer compartment
is still too warm.
Switch off the warning tone using
2.
.
goes out as soon as the
a
set temperature has been reached.
Set the required temperature.
3.
→ Page 19
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and side panels of
the housing heat up occasionally.
This prevents condensation from
forming.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
¡ The temperature in the appliance
varies due to the following condi-
tions:
– How often the appliance is
opened
lights up
– Load capacity
– Temperature of newly stored
food
– Ambient temperature
– Direct sunlight
7.3 Switching off the appli-
ance
Press and hold
▶
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Select the refrigerator compart-
1.
ment using
Press
/
repeatedly until the
2.
temperature display (refrigerator
compartment) shows the required
temperature.
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→ Page 19
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the storage container
temperature
To reduce the temperature, slide
1.
the temperature controller in the
direction.
To increase the temperature, slide
2.
the temperature controller in the
direction.
operation en
for ten seconds.
.
19
Table of Contents
