PLEASE READ BEFORE OPERATING THIS EQUIPMENT
This product is manufactured and sold by Curtis International Ltd. RCA, the RCA logo, the two dogs (Nipper and Chipper) logo, are registered trademarks or trademarks of RCA Trademark Management and are used under license by Curtis International Ltd. Any other product, service, company, trade or product name and logo referenced herein are neither endorsed nor sponsored by RCA Trademark Management or its affiliates.
Ideal for dark viewing environments for optimal performance.
Please note: Projector brightness is measured in ANSI lumens. Your viewing environment is the deciding factor on how many lumens your projector needs.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Remove the lens cover before using
Close the lens cover when unit not using
Your projector can be installed in four different configurations (see picture below):
Front Table:
Select this location with the projector placed near the floor in front of the screen. This is the most common way to position the projector for quick setup and portability.
Rear Table:
Select this location with the projector placed near the floor behind the screen.
NOTE: That a special rear projection screen is required.
Front Ceiling:
Select this location with the projector suspended upside-down from the ceiling in front of the screen. NOTE: A projector mount is required to install the projector in a ceiling.
Rear Ceiling:
Select this location with the projector suspended upside-down from the ceiling behind the screen. NOTE: A projector mount is required to install the projector in a ceiling.
A special rear projection screen is required.
Measure the distance between the projector and where you want to position the screen. This is the projection distance.
Distance | Screen Size |
1.16m | 37 inch |
1.35m | 45 inch |
1.51m | 50 inch |
1.81m | 60 inch |
2.15m | 72 inch |
When installing the projector in the ceiling, please purchase a projector mount recommended by an installation professional and follow the instructions that come with the mount.
Before installing the projector in the ceiling, please check to make sure the ceiling structure can support the weight of the projector and the mount. If in doubt, please ask the advice from an installation professorial.
NOTE: Projector mount and screw(s) not included
Follow below picture to adjust the vertical location.
Follow below picture to adjust the focus and trapezoidal screen.
Adjust the focus by turning the knob while observing the image pixels near the center of the screen. Optimal focus is obtained when the pixels are clearly visible. Depending on the projected screen size, the focus near the screen edges may be less sharp than the screen center.
Keystone image is created when the projector lens is projected from above or below the center of the screen. Keystone correction restores the distorted image to a rectangular or square shape.
Remove the battery compartment cover on the back of your remote by carefully sliding to open. The battery cover can then be lifted away. Fit the correct batteries (not included), referring to the polarity markings. Finally, replace the cover.
NOTES:
Follow below picture to connect power adapter
Connect small end of adapter FIRST. Plug the adapter body to power outlet.
Before connecting to the power supply, ensure that the supply corresponds to the information on the rating label at the back of the apparatus.
- Press the button to turn on unit, press again to turn off.
/ SOURCE - Press the button to select input source.
/ MENU - Press the button to enter projector menu.
- Press the buttons to navigate and select screen item of menu.
/ EXIT - Press the button to return to previous status or exit the menu.
- Press the buttons to fast search forward and rewind on USB / TF.
Press the buttons to search next or previous file on USB / TF.
- Press the buttons to select the sound level.
- Press the button to play/pause the playback of file on USB / TF card.
FLIP - Press the button to rotate / mirror projector screen
ZOOM - Press the button to select image scale.
- Press to mute the audio. Press again to resume.
Refer to the following picture to connect a set top box, a BD/DVD player or a streaming player to the HDMI input.
Important Note:
If there is no sound from the internal speakers when playing media contents from a set top box, BD/DVD or streaming players connecting to the HDMI input, please check the set top box or the player's digital audio settings and make sure it is set to "PCM Stereo" mode.
Follow below picture to connect AV cable and device.
Follow below picture to connect VGA cable and device.
Please refer to the following table to adjust the output signal from computer
Type | Resolution | Frequency | Field Frequency | |
PC | VGA | 640x480 | 31.5 | 60 |
34.7 | 70 | |||
37.9 | 72 | |||
37.5 | 75 | |||
SVGA | 800x600 | 31.4 | 50 | |
35.1 | 56 | |||
37.9 | 60 | |||
46.6 | 70 | |||
48.1 | 72 | |||
46.9 | 75 | |||
XGA | 1024x768 | 40.3 | 50 | |
48.4 | 60 | |||
56.5 | 70 |
NOTE: In order to get the sound from the unit, please connect AV IN cable when you connect VGA input.
Follow below picture to connect audio cable and device.
Important Note:
If there is no sound from the stereo audio output when playing media contents from a set top box, BD/DVD or streaming players connecting to the HDMI input, please check the set top box or the player's digital audio settings and make sure it is set to "PCM Stereo" mode.
Follow below picture to install USB and TF card
Turn off the unit before install USB / TF card.
Install USB / TF device:
NOTE: Remove USB / TF device, press the button twice to turn off power FIRST.
Sub-Menu on Photo screen | |
| |
Sub-Menu on Music screen | |
| |
Sub-Menu on Movie screen | |
| |
Sub-Menu on Text screen | |
|
Pairing is the term used when two Bluetooth devices are connected wirelessly for the first time. This allows the devices to see each other and sets up a one to one communication channel between both devices.
Bluetooth Connection
Disconnect the Bluetooth
Press button to enter projector menu.
This Picture menu showed on right upper of view screen.
Use to select different picture effect to Standard / Soft / User / Vidid. Use or to select Contrast / Brightness / Color / Sharpness digit If chose User item. Follow below figure.
Use buttons to select different color temperature to Cool / Medium / Warm / User. Use or to select Red / Green / Blue digit If chose User item. Follow below figure.
Use buttons to select screen ratio AUTO / 4:3 / 16:9. Follow below figure.
Use buttons to select Off / Low / Middle / High / Default.
Use buttons to select 75% - 100%
Picture Mode | |
Customer define | Parameter |
Contrast | 0-100 |
Brightness | 0-100 |
Color | 0-100 |
Sharpness | 0-100 |
Color Temperature | |
Customer define | Parameter |
RED | 0-100 |
GREEN | 0-100 |
BLUE | 0-100 |
Aspect Ratio | |
4:3 | The signal in a 4:3 aspect ratio projection image |
16:9 | The signal in a 16:9 aspect ratio projection image |
Press button to enter projector menu, press buttons to select SOUND menu.
This SOUND menu showed on right upper of view screen.
Use to select different sound effect Standard / Music / Movie / Sports / User.
Use or to select Treble and Bass digit if chose User item. Follow below figure to set digit.
Use buttons to select Balance level to -50 to +50.
To select On / Off
To select On / Off
Sound Mode - User | Parameter |
Treble | 0-100 |
Bass | 0-100 |
Press button to enter projector menu, press buttons to select OPTION menu.
This OPTION menu showed on right upper of view screen.
Use button to select different language. Follow below figure.
Use buttons to select Y or N. If choose "Y" that your unit will go to factory default setting.
To select different project direction
Normal / left-right mirror / up-down mirror / left-right and up-down mirror.
To select 5S, 10S, 15S, 20S, 25S, 30S, Never
For service center use only
Czech | English | French | Hungarian | Polish | Romanian | Slovak |
Danish | Spanish | Croatian | Dutch | Portuguese | Serbian | Simplified Chinese |
German | Greek | Italian | Norwegian | Romanian | Finnish |
Ideal for dark viewing environments for optimal performance.
Please note: Projector brightness is measured in ANSI lumens.
Your viewing environment is the deciding factor on how many lumens your projector needs.
Bluetooth Version | 4.2 |
Light Source Type | LED |
White light output | ANSI IDMS V1.03 SECTION 15.3 33 LMS |
White brightness output | ANSI IEC/ISO 21118 33.1LMS |
Display Native Resolution | 800 x 480 RGB |
HDMI Input Supported Video Resolution. | 1080p, 1080i, 720p, 576i, 480p, and 480i |
Power Consumption | Operating 30W; Standby 1.1W |
Power Input Connect Included Adapter | DC 12V, 2.5A |
Included Adapter | Input AC100-240V,50/60Hz |
Connect DC input of unit | Output DC12V, 2.5A |
Display Color | 16.7M |
Projection Size | 37-100 inch |
Input Port | AV/ VGA / HDMI X 2 |
USB Port | Support USB device up to 32GB Support format Mpeg1, Mpeg2, Mpeg4, mp3, Jpeg |
TF Card | Support TF card up to 32GB Support format Mpeg1, Mpeg2, Mpeg4, mp3, Jpeg |
Net Weight (unit) | 0.95 KG |
Product Dimensions | 7.9" L x 6.1" D x 3.3" H |
Specifications are typical, individual units might vary. They are subject to continuous improvement without notice and without incurring any obligation.
For service assistance and product information, please call: 1-800-968-9853.
Pour obtenir assistance et information appelez: 1-800-968-9853.
Curtis International Ltd.
7045 BECKETT DRIVE, UNIT 15, MISSISSAUGA, ON, L5S 2A3
www.curtisint.com
To make a warranty claim, do not return this product to the store. Please email [email protected] or call 1-800-968-9853.
90 day Warranty
This product is warranted to be free from defects in material and workmanship for a period of ninety (90) days from the date of original purchase. During this period, your exclusive remedy is repair or replacement of this product or component found to be defective, at our option; however, you are responsible for all costs associated with returning the product to us. If the product or component is no longer available, we will replace with a similar one of equal or greater value. Prior to a replacement being sent, the product must be rendered inoperable or returned to us.
This warranty does not cover glass, filters, wear from normal use, use not in conformity with the printed directions., or damage to the product resulting from accident, alteration, abuse, or misuse. This warranty extends only to the original consumer purchaser or gift recipient. Keep the original sales receipt, as proof of purchase is required to make a warranty claim. This warranty is void if the product is used for other than single-family household use or subjected to any voltage and waveform other than as on the specified rating on the label (e.g., 120V~60Hz).
We exclude all claims for special, incidental, and consequential damages caused by breach of express or implied warranty. All liability is limited to the amount of the purchase price. Every implied warranty, including any statutory warranty or condition of merchantability or fitness for a particular purpose, is disclaimed except to the extent prohibited by law, in which case such warranty or condition is limited to the duration of this written warranty. This warranty gives you specific legal rights. You may have other legal rights that vary depending on where you live. Some states or provinces do not allow limitations on implied warranties or special, incidental, or consequential damages, so the foregoing limitations may not apply to you.
For faster service, locate the model, type, and serial numbers on your appliance.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.