Table of Contents
USB 3 (5 Gbps) connectors
The USB 3.2 Gen 1 (5 Gbps) connectors are direct connect interfaces (DCIs) for debugging, which can be
used to attach a USB-compatible device, such as a USB keyboard, USB mouse, or USB storage device.
VGA connector
The VGA connectors on the front and rear of the server can be used to attach a high-performance monitor, a
direct-drive monitor, or other devices that use a VGA connector.
XCC system management port
The server has a 1 GB RJ-45 connector dedicated to Lenovo XClarity Controller (XCC) functions. Through
the system management port, you can access the Lenovo XClarity Controller directly by connecting your
laptop to the management port using an Ethernet cable. Make sure that you modify the IP settings on the
laptop so that it is on the same network as the server default settings. A dedicated management network
provides additional security by physically separating the management network traffic from the production
network.
For more information, see:
•
Set the network connection for the Lenovo XClarity Controller
•
"XCC system management port LEDs" on page 33
Ethernet connectors
Figure 3. OCP module (two connectors, seen from the
rear)
The OCP module provides two or four extra Ethernet connectors for network connections. By default, any of
the connectors on the OCP module can function as a shared management connector.
Top view
This section contains information on the top view of the server.
The following illustration shows the top view of the server without any air baffle, middle cage, or rear cage
installed.
Figure 4. OCP module (four connectors, seen from the
rear)
Chapter 2
.
Server components
19
Table of Contents
