Table of Contents
Programming
2
Select your desired groups by pressing
1 to 9.
R " " is displayed next to the selected
group numbers.
R To cancel a selected group, press the
same dial key again. " " disappears.
3
MSaveN a MOFFN
Call block
This feature allows the unit to reject calls when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted ("Storing unwanted callers",
page 28).
– the unit receives a call without phone
number ("Blocking incoming calls without
phone number", page 28).
When a call is received, the unit rings for a
*1
short time
while the caller is being identified.
If the phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call. (Call Display
subscribers only)
*1
This is called first ring. If you do not want
the first ring to sound, turn this setting to
"Off" (page 28).
Important:
R When the unit receives a call from a
number that is stored in the call block list or
a call without a recognized phone number,
the call is logged in the caller list
(page 35) with
after the call is
disconnected.
Storing unwanted callers
You can store up to 100 phone numbers in the
call block list.
Important:
R You must store the phone number with an
area code in the call block list.
n From the caller list:
1
MCN CID
28
PRW130C(en)_0311_ver110.pdf
n By entering phone numbers:
Blocking incoming calls without
phone number
You can reject a call when no phone number
is provided, such as a call just showing
"Unavailable Name & No.".
1
2
3
Setting the first ring for the call block
list
If you do not want the first ring from a number
on the call block list to sound, turn the first ring
setting to "Off". The default setting is "On".
1
2
3
28
2
MbN: Select the entry to be blocked. a
MDetailN
R To edit the number: MMenuN a
MbN: "Edit" a MSelectN
Press MEditN repeatedly until the
phone number is shown in the
10-digit format. And then, press
MSaveN. Go to step 5.
3
MMenuN
4
MbN: "Save CID" a MSelectN
5
MbN: "Call block" a MSelectN
6
MbN: "Yes" a MSelectN
7
Edit the phone number if necessary
(24 digits max.).
8
MSaveN a MOFFN
1
MMenuN (right soft key) #217
2
MMenuN a MbN: "Add" a MSelectN
3
Enter the phone number (24 digits
max.).
4
MSaveN a MOFFN
MMenuN (right soft key) #240
MbN: Select the desired setting. a MSaveN
MOFFN
MMenuN (right soft key) #173
MbN: Select the desired setting. a MSaveN
MOFFN
2014/03/11
13:06:43
Table of Contents
Troubleshooting
